Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Mar 04 22:38:54 EST 2021 | tomek_k
Hi Miałem taki problem, myślałem też że to uszkodzona karta Cognex. Zakupiłem nową i to nie pomogło. Okazało się że trzeba zainstalować właściwy sterownik karty. (translate from PL) regards Tomek
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Mon Jan 14 12:28:06 EST 2008 | swag
We are in North Western U.S. I like 2.6 better (for our mix of builds, anyway). 1.0 works great on PTF parts such as fine pitch QFP's but I don't like it for chips. It's too picky and we wind up forcing parts to the 4.0. We have another GSM dual
Electronics Forum | Fri Dec 14 19:56:40 EST 2018 | denisss
Good afternoon, the problem gives an error vision gantry x, an error occurs after the camera approaches the car wash and hits the piston, what could be the matter? are there any real specialists gives an error after a certain working time of 40 minut
Electronics Forum | Wed Mar 27 02:36:27 EDT 2024 | dekhead
DEK 265LT was not mfg until 1995/6, verify model; what camera (4 possibilities on LT) is on machine? Have you verified / replaced video cable from camera all the way back to cognex?
Electronics Forum | Mon Mar 11 13:02:07 EDT 2024 | denism
Hi, Did you check power cable to the camera? It is can be the reason.
Electronics Forum | Wed Apr 07 21:49:44 EDT 2004 | Ken
My favorite kind of calibration is where the machine learns what it did incorrectly. Then fixes itself! However, there are many types of machines that rely on human feedback as to the results of what it did. nozzle calibrations involve many factors
Electronics Forum | Mon Apr 26 08:15:37 EDT 2004 | pjc
MPM uses a one-print-Mylar system, as do other printer mfrs. In this system there is a Mylar sheet attached to a frame that is secured over the printer table with the board on it. You print onto the Mylar. The table X-Y-theta manual adjustments are u
Electronics Forum | Wed Feb 14 08:48:57 EST 2024 | andrii
hi, I have very very old DEK 265 Lt And I have a problem that Mr. processman described a long time ago. But no one answered him. Maybe someone can help me now? "We have a strange issue with a DEK 265 Lt, it powers up and initialises fine. Camera LE
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
winsouce.jpg)
.gif)
