Electronics Forum | Tue Oct 05 15:39:35 EDT 2010 | daxman
Hi Steve, I don't know if there are a lot of people who can decrypt the trace data. I think the manual mentions sending it to fuji for analysis. Maybe that would be something worth checking into. Regarding the Mecca check mode: I don't know if it wi
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Fri May 02 19:02:21 EDT 2014 | mac5
You will have to open each parts Shape Data, Click on the Shape Process tab, Click on the Process tab, towards the bottom of the page under Error change the Dump Position to Box. This should work. Good luck.
Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Fri Jun 26 06:32:33 EDT 2020 | dltechltd
Dear Victor, We have figured out what caused the error: One of it's MVS ICOS card had parity error (The MC reported that error too as seen in the previous pictures). We could see RED LED Light on the card, and we have pulled out, and checked: PAR_ER
Electronics Forum | Thu Jul 15 11:28:24 EDT 1999 | Russ Supersano
I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed and I had to reload the software. I re-insatalled Venix then the CP4 driver then TPsys and Ser
Electronics Forum | Wed Nov 16 14:44:31 EST 2011 | olddog
Bobpan, thank you for your speedy response. As to the items you noted: 1. I did a test of Funct 30 for the first 5 nozzles, 2 times each as follows: noz1 Ht=215 & 219, center=1005 (all nozzles all tests), run out 2.2 & 2.7. Noz2 Ht=228 &228, runout=
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Fri May 04 01:34:07 EDT 2007 | dsd
Your Head 1&2 have Chucks, is Head 3 a Chuckless Head? The Chuckless Head or Precision Head is the intended Head for use with the Centering Station only. Using Head 1 & 2 is not good as there is too much nozzle play. In your Machine Configuration is
Electronics Forum | Thu Jul 15 21:10:53 EDT 1999 | Scott McKee
| I was wondering if someone could help me with a little problem I am Having with a MyData TP-11 UFP running TPSys 1.4.2. Early this week the machine crashed and I had to reload the software. I re-insatalled Venix then the CP4 driver then TPsys and S
