Electronics Forum | Wed Jun 16 15:07:00 EDT 2004 | jsmith01
I ran some test samples with a water soluble past (Amatech ws488). I also tried hand soldering using an Alpha ws375 wave soldering flux and some old fashioned RMA. The results are pretty much the same. Some of the joints look a better that others b
Electronics Forum | Tue Jun 24 17:41:29 EDT 2003 | MikeF
I'm looking for an esd safe tray, something like what pharmacists use, that we can use to count out loose parts. Has anyone seen something like that? We have a lot of part values in our stock room that have maybe 100 or so loose parts in a bag. The
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Fri Jan 08 08:29:48 EST 2016 | ahanna
Water can be the issue. After Christmas break we came back to find a fair amount of water build up in our airlines for the building. I will check out the regulator as well as the solenoid. Thank you. I appreciate it.
Electronics Forum | Fri Jan 08 06:14:32 EST 2016 | bobpan
There should be a regulator to adjust the puff off on the inside left back panel. Remove the left side cover to get to it. Write down what its set at prior to adjusting it. I have also seen this problem caused by water in the system. Make sure that y
Electronics Forum | Fri Nov 09 14:30:17 EST 2001 | vickt
FYI...Universal has software that "senses" if parts are present in the PTF trays or not. With some upgraded s/w your dumping would be over
Electronics Forum | Thu Mar 08 06:45:30 EST 2001 | genglish
I am having a problem with a Universal GSM machine (Platform Tray Feeder)dumping trays with parts still in the trays, subsequently damaging the leads. Is it possible to program the machine so if any part is not picked from the tray in the matrices a
Electronics Forum | Thu Mar 08 16:00:03 EST 2001 | gsmguru
Enter A value of -1 in the Tray pickup X & Tray pickup Y fields. This will disable the automatic empty tray pickup by the machine. I would recommend getting a data sheet on the tray from the component vendor for accurate pocket & tray dimensions. Var
Electronics Forum | Mon Jan 23 08:15:33 EST 2006 | pavel_murtishev
Good day, Vibratory (MultiStick) feeder is bottleneck of any placement machine. If you feed expensive IC�s via vibratory feeder they surely will be damaged. If you really care about expensive IC�s equip you placement machine with reject conveyor. In
Electronics Forum | Thu Mar 08 09:08:47 EST 2001 | jax
Your safest bet is to manually remove the trays. The problem with what you want is that the machine does not know that it missed a part. It simply goes to the point you specify and tries to pick somthing up; if it doesn't pick up anything it believes
