Electronics Forum | Thu Nov 04 07:01:43 EDT 2010 | clampron
Good Morning, I had looked into this several years ago. The Swiffer dust mops use static to capture and contain dust particles. That would make this a huge ESD concern. Electrical SMT equipment is grounded so any charge potential generated would be
Electronics Forum | Fri May 11 17:21:04 EDT 2001 | davef
Three main groups of depaneling equipment are: 1 Scoring: Limited to straight edges and mainly 90� angles 2 Routing: And a cloud of dust 3 Singulating: Hard tooled by board To get started understanding the suppliers look here: http://www.cassembly.c
Electronics Forum | Tue Sep 15 10:19:23 EDT 1998 | dave c
| Dave, | How thick are your PCBs? Do you have adequate topside preheat or are the bottom preheaters turned up to ensure proper filleting on the top side? | Rob Rob, The average PCB is .062". There is no topside preheaters on our machine
Electronics Forum | Tue May 25 18:08:19 EDT 2021 | scarittagle
A certain degree of cleanliness is needed in SMT manufacturing environment but not as overkill as place it in a "clean room" environment... Yes, dust could cause defect on PCBAs (and there are research papers about it too) but onl
Electronics Forum | Wed Sep 16 15:45:28 EDT 1998 | Rob Fischer
| | Dave, | | How thick are your PCBs? Do you have adequate topside preheat or are the bottom preheaters turned up to ensure proper filleting on the top side? | | Rob | Rob, The average PCB is .062". There is no topside preheaters on our
Electronics Forum | Mon Sep 14 09:09:10 EDT 1998 | Earl Moon
| I am running composite fixtures on my wave solder machine and after about 500 passes each (1 month)they are showing serious signs of wear in that the composite surface is bubbling up and glass fibers are also starting to show. | The problem here
Electronics Forum | Mon Mar 05 11:32:34 EST 2012 | davef
As long as you're convinced that your ionized air gun is not a static generator, it should work fine in dedusting your boards. As you say, covering your board racks while the boards are being stored is probably a better solution. If you google 'esd
Electronics Forum | Wed Feb 29 16:18:22 EST 2012 | jorge_quijano
Hello guys, I have an issue and I hope you can share some comments; I'm in a High mix low volume enviroment, as result I have several PCBs "stored" in carts, what is the best method to clean it? they have a lot of dust, I think ionized air gun will w
Electronics Forum | Wed Jan 22 11:05:25 EST 2020 | dwl
Routing is great for odd shaped PCBs that don't lend themselves to v-scoring. changing from one shape PCB to another is easy. The down sides are you may require custom support tooling and they generate alot of dust. keeping up with the PM will be cri
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
