Electronics Forum | Tue Dec 21 12:55:41 EST 2021 | oclsc
Hi SMTnet. I am planning to inspect the nozzles for our Fuji Aimex II on more regular basis. We have the H12HS and DX mountingheads. Are the any of you have there have some experiences in how often this should be done? I do know that it depends on t
Electronics Forum | Tue Aug 03 14:28:23 EDT 2010 | keiths487
the "hooks" appear to be in good shape and are holding the nozzles up...machine will run even utilizing those head/nozzle combinations...we will check the valve, and verify proper operation, during non-production time....
Electronics Forum | Thu Mar 22 17:18:17 EDT 2018 | rodrigo
Hi all, Our (new/used) CP642 resets the nozzles heads first time I do a nozzle centering after power on. But we're getting errors st17 and st19 and while working on the sensors I noticed that it does not resets the heads before I start a nozzle cent
Electronics Forum | Tue Aug 03 17:45:43 EDT 2010 | swag
I used to wrench on those all the time! I really should be more help to you but it was a few years ago... A few more things to check - clean the line sensors on the back of the machine. Check to make sure you don't have a feeder that is allowing t
Electronics Forum | Wed Aug 04 08:40:37 EDT 2010 | keiths487
I used to wrench on those all the time! I really > should be more help to you but it was a few years > ago... A few more things to check - clean the > line sensors on the back of the machine. Check > to make sure you don't have a feeder that i
Electronics Forum | Mon May 21 09:04:15 EDT 2012 | cbeneat
We've had the same issue on our Panasonic CM machines with Cree XP type LEDs. Count on tools makes a urethane tip nozzle that we are using which eliminates the sticking, our concern with these is durability. Nozzle supply company makes a steel Teflo
Electronics Forum | Tue Jul 21 06:59:53 EDT 1998 | WAYNE
| Panasonic Create: What (Where) are your pad design and design quidelines that you have in-place? Dave F Dave" Thanks for the response. Many people I have talked with are interested in 201's, but are not placing at this time. I am curious about
Electronics Forum | Thu Mar 09 00:45:57 EST 2006 | kent_peterson
Fastek will get it done with 2 machine and 2 shifts. 2 shifts would need to place 50,000cph. One CP643 with both device tables set could get it done. Having it panelized in 50's, you would need to print 50 panels a hour so get a auto cleaner on the p
Electronics Forum | Tue Apr 01 17:14:11 EDT 2008 | aj
Hi, We only have 2 lines , but I dont allow any of the Ops to set them up, I did once and winded up with 10 damaged nozzles and cracked caps on the boards ... If the problem is as big as you say it is , you should really spend some time setting it
Electronics Forum | Tue Apr 01 08:28:19 EDT 2008 | cyber_wolf
DANGER WILL ROBINSON ! DANGER ! If your operators are not real careful the OEM support pins can get under the table frame and bend it. I have seen this happen more times than I would like to discuss. CP's must have the following: 1. Proper part hei
