Electronics Forum | Thu Oct 20 15:44:16 EDT 2022 | smtusa
What about MY100? Its based on the same high speed hydra head just two of them. Do you not recommend those as well? Originally, I was looking at a MY9 before spending on a MY100dx. Certain things mydata do make it attractive but im a low mix, high
Electronics Forum | Thu Dec 15 07:28:38 EST 2016 | emeto
Hello experts. Can anyone tell me how to force part to go to Hydra heads on MYDATA machines? I have MY200DX. Especially interested in Electrolytic caps placement.
Electronics Forum | Mon Aug 18 12:01:19 EDT 2008 | cyber_wolf
Is there anyone out there using the new Mydata MY100 series machines ? We are looking into a MY100DX-12 or a MY100DX-14 machine. I am interested in all comments...good..bad... Thanks in advance.
Electronics Forum | Wed Mar 30 19:37:17 EDT 2022 | jzeivel
I have an MY200DX mycronic pick and place machine. I recently started getting this error "F-MOT-MOVENICE HYDRA Theta2/1295: Encoder Signal is noisy". Has anyone else ever had this error? The machine will still run, but this error will pop up rando
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Fri Jan 05 16:16:51 EST 2024 | mistrthou
Based on the my15 we used to have and our current My100's I'd say it lost the position of the tool bank. Is it Hydra or Midas tooling? Uninstalling and reinstalling the hydra tool bank is fairly easy. If it's Midas tools, does it fetch other tools
Electronics Forum | Tue Apr 02 18:25:00 EDT 2024 | kingkelvin
Yes very good - thank you, I'm getting the specific hydra tool offset jig from PFI Florida for $100 - and MyData has already quoted me all the other parts such as in that box there - so I'll get some of these in and continue my work. Thanks all!
Electronics Forum | Wed Feb 25 12:36:18 EST 2015 | Svajunas Astrauskas
Our company have Mydata MY100DX mashine. When assembling project it lags. Assembling - several seconds thinking (sometimes till 10secons) - assembling and this problem repeats all time. When button is pushed it sometimes reacts only after 1-10 secon
Electronics Forum | Thu Jul 09 11:12:43 EDT 2015 | quaker332007
We have a mydata MY100DX and A Hover-Davis label feeder. I'm have issues picking up the label. The machine will place it fine for a few then stop and refuse to pick up the label. Is anyone using this configuration and if so do you have and points
.png)
