Electronics Forum | Sat Dec 30 18:49:39 EST 2006 | A.S.
TRY TO REPROGRAM THE AXISES AND CHECK THE WIRES GOING TO THE E-STOP BUTTON THESE PROBLEMS CAN CUASE THESE ERROS TO KEEP COMING UP TRY THIS AND YOU MAY FIX YOUR PROBLEM
Electronics Forum | Thu Jul 18 12:45:49 EDT 2019 | dekhead
Lots of things it could be (basics first): E-Stop pressed. Connections within E-stop circuit (mostly Y4). Connection of SYSTEM switch back to Y4. E-stop relay. Do double pushbuttons toggle partial SYSTEM?
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Tue Apr 23 07:40:30 EDT 2019 | kayvee
Check the E-stop switches are not latched in, I have noticed you get weird startup errors if they are.
Electronics Forum | Mon Jul 10 16:37:10 EDT 2006 | mac
Hi All, Lately we have been getting a humming noise which seems to be coming from one of the D-axis motors on the CP4. If it happens the Op. hits the e-stop and resets the machine which clears the noise and machine runs fine. Obviously there is a
Electronics Forum | Wed Jun 08 09:37:20 EDT 2005 | james
Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I
Electronics Forum | Wed Jun 08 12:04:34 EDT 2005 | james
Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I E-s
Electronics Forum | Fri Dec 22 12:58:23 EST 2006 | MFG CAVEMAN
Simon, In a previous life, I came upon a maintenance tech that had an old vapor phase oven control cabinet half ripped apart for a main power problem. I asked him if he had checked to see if any of the E-Stop swtiches had been hit. One had been ac
Electronics Forum | Fri Aug 28 17:24:28 EDT 2020 | stephendo
Did you check all the voltages and fuses? The second worst is when a machine is down for a while and it ends up being something basic. The worst is when it started as something basic and someone introduces a new problem. Also could there be any opti
Electronics Forum | Thu Feb 24 12:48:45 EST 2000 | Larry Johnson
I have seen this problem several times on several different IP3's... When the MTU is about to pick a part from the tray, the machine will just stop. No error, just says, "producting", in green. E-stop, reset and start again, and you hear air from
