Electronics Forum: each (Page 188 of 304)

C'mon now friends.. I know you can help here....

Electronics Forum | Thu May 10 17:33:05 EDT 2007 | bkgsmtnet

Thank You Mark!. I appreciate your time. I have contacted them for a demo. Looks like they only handle the quoting aspect. I am also looking for Scheduling, Order, Inventory management suggestions. There has got to be a software that you can define y

Solder wave shutdown

Electronics Forum | Tue Jun 12 14:29:01 EDT 2007 | realchunks

You'll need to calibrate your effectiveness to the deliverables of the adhsive quality and initiate the description of the criteria for requirements by developing a framework for the application architecture consistent with the planning corridor spec

Losing parts in reflow

Electronics Forum | Wed Jun 13 15:56:35 EDT 2007 | ck_the_flip

I experienced this with a high-mass capacitor. I was able to turn down the bottom-side convection (around 50�C lower than each of the top-side heaters), and able to NOT lose any parts. I got the bottom-side part just slightly over liquidus, and min

Mydata A12 tool tip damage

Electronics Forum | Wed Jul 18 03:55:39 EDT 2007 | allgood

Thank you for the reply - and yes its a TP9-UFP! Problem doesnt happen all the time and may not happen for extended periods on the job where we see it most - this particular job uses all feeder slots so the head is whizzing back and forth quite a l

Universal Instruments Radial Inserter

Electronics Forum | Mon Jul 30 15:28:25 EDT 2007 | gmoritz

I'm posting a diary of the major repair experience that we had this weekend. I'll follow up with a shorter post that sort of summarizes a few things. ------------------------------------------------ The service guys showed up at our facility about

Universal Instruments Radial Inserter

Electronics Forum | Mon Aug 06 14:05:02 EDT 2007 | slthomas

BEC hardware would be on the machine as a sensor underneath the placement table, to the left of the C&C, and an emitter attached to a bracket to the left of the insert head. The two line up with each other and the sensor uses a quadrant layout to det

Universal 4796B Questions...

Electronics Forum | Sat Aug 11 15:59:10 EDT 2007 | bentigano

Hello cuculi. I was actually the guy you sent the .pl file to a while back to help me out with the .800 program optimization. Speaking of which, the Perl code reminded me a lot of PHP, and was extremely helpful, so thanks again. Hopefully I'll be ab

Dedicated or adjustable fixtures for Universal Radial Inserter

Electronics Forum | Wed Aug 29 11:22:11 EDT 2007 | gmoritz

Thank you for the answers to my questions. We are running two-lead LED insertions. Most of our PCBs are square between 9" and 14.25" in a 16 x 16 array, so pitch ranges from 0.52" to 0.90". Further complications are that most of the boards have th

AOI side cameras

Electronics Forum | Fri Sep 07 17:38:23 EDT 2007 | bentigano

Hello James. I've got a YesTech YTV-2050 system at work with one top-down camera, and 1 side-view camera for each of the four sides. I do have the side view cameras being used for automated side inspection. There are some parts with markings that are

GSM Calibration Error code 6

Electronics Forum | Sat Sep 22 02:14:08 EDT 2007 | mika

Another thing to make sure of and the vision calibration system will fail if this is out of range: Use a magnet foot stand micrometer and measure the spindle run outs. First remove the nozzles and nozzle adapters, then put the adjustable tip (I dont


each searches for Companies, Equipment, Machines, Suppliers & Information