Electronics Forum | Sat Mar 12 08:03:11 EST 2005 | smtuser1234
The company is Eagle Eyed One. I worked with this company and he does an excellent job.
Electronics Forum | Thu Mar 10 11:39:54 EST 2005 | gregp
Click on OnBoard Forum under electronics forum. The last on board forum was by a guy who specializes in what you ask about. The company is Eagle Eyed One.
Electronics Forum | Mon Jul 07 21:08:17 EDT 2003 | sam
I have an experience about AOI that it is necessary in a complicated PCB. Due to the final circuit design, the concerned PCB were having nets on the boards, that the Open/Short could not be identified by traditional In-Circuit testers. Some long tr
Electronics Forum | Mon Aug 26 23:35:08 EDT 2002 | Dave
Hey there, we use... Hmmms... we use a 6 hour paste I think from sci-tech or something that sounds like that, ws160a. as a rule what I paste up first thing, I want in the oven just after lunch, so about 4-5 hours. anything over that and your playin
Electronics Forum | Mon Apr 30 18:29:40 EDT 2007 | grantp
Hi, I wondered that too, which is why I originally replied. However I think what's most important for me anyway, is I am so incredibly busy trying to keep up with the latest techniques in SMT and electronics, that I have no idea about these issues
Electronics Forum | Sat Feb 08 04:37:19 EST 2020 | spoiltforchoice
I work with small batches and this is what I do. However I don't do it because of the paste. Instead I do it because I am the sole operator on the line and I want one process finished so I can keep a better eye on the others. I specifically work with
Electronics Forum | Fri Mar 24 17:07:39 EST 2000 | John Thorup
Hello Ashok If you are talking about the thousands of volts that is often generated by either simply unrolling the tape to apply or when it is removed from the board after soldering you don't have a lot of choice since it is an insulator. Ionization
Electronics Forum | Fri Feb 23 10:07:32 EST 2001 | jmlasserre
I would like to have some advise or explaination about the IPC610 spec. Page 6-51 and 6-52 concerning the solder stains on gold finguers: On the page 6-51, it's recommended to inspect the gold finguers with the unaided eye, but on the page 6-52, th
Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Mon Jul 31 10:51:11 EDT 2006 | Chunks
OK so you're stuck with gold. Not all that bad unless you're paying for it. Gold is very flat compared to HASL, so you should have no problems printing. This should lead to good placement as well. But after oven you mat have a big contrast betwee
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
