Electronics Forum | Thu Mar 02 17:32:09 EST 2006 | sphilips
The initial cost of the battery is similar to saying the size of an iceberg is measured only by what shows above the waterline. There is a lot more to it than at first blush. The ECD Power Pack costs $245, but provides over 3500 hours of profiling.
Electronics Forum | Fri Mar 03 20:45:58 EST 2006 | KEN
I have used KIC data acquisition equipment for over 11 years. Slim kic, sideKic and Kic2000, prophet etc... The 9 volt battry changes in seconds. Gimme a break. The internals don't reach 54Celsius. If it came down to batteries, I bet KIC would t
Electronics Forum | Tue Feb 21 07:58:35 EST 2006 | Aaj
Comparing KIC and ECD Gold mole profilers, which one is easier to buy batteries for? and why?
Electronics Forum | Wed Jul 31 10:03:44 EDT 2002 | gdstanton
Todd, Slim KIC 2000 would be my choice. We traded our Gold M.O.L.E for it and are very happy with the performance. The optimization program is great. No more guessing. The only thing I could gripe about is that it sucks up 9V batteries pretty quic
Electronics Forum | Wed Sep 22 12:23:11 EDT 2004 | Peter Barton
FYI Label on the back of my charger says the following: Pt. No. WD23D200KCN PSU E31-0900-21 Input 230 V AC Output 9V DC, 0.2A 1.8VA Ours is of course United Kingdom type, even if the mains plug is European and requires an adaptor. Not too sure a
Electronics Forum | Tue Mar 07 11:13:04 EST 2006 | pjc
One difference with ECD from a hardware standpoint is that the M.O.L.E. installs into the OvenRIDER, WaveRIDER and ReworkRIDER products for solder machine process control. You get the same software too. Competitive systems I believe require more hard
Electronics Forum | Mon Jan 04 11:32:59 EST 1999 | Chrys
| Anyone have any experience with ECD's Waverider/MOLE profiling equipment? If so, were they positive experiences? | I use ECD's mole for profiling in the wave and a KIC for profiling in reflow. I like the KIC a whole lot better for a couple of re
Electronics Forum | Mon Jan 04 22:59:23 EST 1999 | Kris Ewen
I'd like to add something about the ECD product. During a past work term (I'm a a co-op student) in an SMA plant, I worked extensively with the Super MOLE Gold in developing the reflow profiles for high-mix, low-volume production. I was 'married' t
Electronics Forum | Mon Feb 26 06:23:38 EST 2001 | johnwatt
Folk's, I've been running with the datapaq system for about 5 years now. I have been using it on both reflow and on wave, the only issue I've ever found is that you cannot predict settings for wave, but then you can't do that on Kic and I don't thin
1 |