Electronics Forum | Wed Nov 27 09:43:17 EST 2013 | mchawg
We recently rebuilt the generator and power supply on our '97 vintage Optiflux Ultrasonic fluxer. That cleared up all its issues except. Ultrasonics are reported by all indicators to be running in both Setup and Run mode, however, the nice rooster-t
Electronics Forum | Mon Sep 22 04:59:10 EDT 2008 | fadzil66
I have concern about cleaning solder ball after misprinting paste on PCB, currently use vigon 200 with ultrasonic generate but only 70% solder ball able to remove, Any other method or equipment can help to clean solder ball.
Electronics Forum | Wed Feb 21 18:07:00 EST 2001 | billschreiber
Hi Ramon, The obvious answer you might expect to here from me is that you could probably reduce your misprint problem if you had a good stencil cleaning process. Please see my response to the question by MarkT on �Cleaning Materials� because it i
Electronics Forum | Mon Jul 24 15:10:37 EDT 2006 | carln
Here are some additional comments that have been posted on the CircuitNet web site: Fist, the answer is the same regardless of the specific paste type, (leaded or non-leaded). High pressure sprays should never be applied to a stencil. Stencils are
Electronics Forum | Thu Apr 28 14:07:24 EDT 2005 | bschreiber
Hello Paul, Prior to 1980, I would say that your concerns were real regarding the resonant frequency. However, since then all major ultrasonic cleaner manufacturers use a "sweep" frequency technology. By "sweeping" or alternating the frequency bet
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Electronics Forum | Wed Jul 11 13:55:26 EDT 2007 | bschreiber
We have received several e-mails and phone calls regarding the Permali recommendation of cleaning Durostone pallets so I thought I would address these questions on the forum for everyone's benefit. Q: Can 440-R SMT Detergent be used for manual clean
Electronics Forum | Wed Jul 24 01:53:58 EDT 2002 | Mike Konrad
Using ultrasonic technology to remove adhesive is normally not that difficult. I do not know who�s machine you are using (perhaps its ours). In any case, here are some tips for removing adhesives. 1. Heated wash chemistry works better than ambien
Electronics Forum | Wed Feb 01 12:20:16 EST 2006 | cvoyles
Hi Bruno, I am an equipment reseller in business since 1994. I have a Smart Sonic MG3000 ultra sonic stencil cleaner in inventory. It is a stainless steel model with Delta Sonics brand ultra sonic generator. It is the guillotine type that raises a
Electronics Forum | Wed Sep 22 14:45:01 EDT 2004 | Michelle Ogihara
As many people have participated in this email string, including competitors and customers of Sawa, I would like to respond to especially one rather detailed email expressing concerns with this stencil cleaning system. Also, this teaches me to keep