Electronics Forum | Fri May 14 11:14:57 EDT 2010 | thanh
wow, no one can figure out why it doing that????
Electronics Forum | Thu Sep 15 16:40:55 EDT 2016 | zippi
Hello, i have a problem with the Calibaration of my Assembleon Eclipse II. There is a problem with the down Z Position of Head 2. They are 2mm deeper as Head1 by picking up any Componend. Laser High are OK. How Can i setup the Head down High.
Electronics Forum | Fri Nov 30 00:51:10 EST 2007 | vinitverma
Here are the differences (Eclipse vs Eclipse II) Optimum Speed: 5000 vs 6500cph Feeder Positions (8mm) : 80 vs 94 PCB Loading Time : 4s vs 5.3s PCB Thickness : 0.6-3mm vs 0.5-4mm Max Component Size : 32mm vs 45mm (optional camera possible on Eclipse
Electronics Forum | Wed May 02 08:59:30 EDT 2007 | Mario
Hello, What could be the cause of the skewed mounted LXHL PW01 kinds of POWERLEDS? Is the bad recognition (although detected sucessfully)or the machine is uncalibrated? The machine used is Eclipse II from Assembleon. What workarounds can be made to
Electronics Forum | Wed May 05 16:12:30 EDT 2010 | thanh
after calibration, now i'm having an issue that placement between lazer and camera off about .5mm on the Y mount. if parts go to camera, the placement are good. but parts that placing with lazer it off about .5mm at Y for all rotation. anyone seen t
Electronics Forum | Sun May 16 00:07:58 EDT 2010 | tpappano
I have a Philips CSM84VZ. There are offset calibrations that compensate the X and Y distances from the camera to the heads and the beam pointer. Perhaps yours is similar and just needs a small Y adjustment for the beam pointer.
Electronics Forum | Tue Jun 01 15:06:40 EDT 2010 | thanh
I did. Nothing change. I can go in mount feed back and increase .5mm for all rotations(Lazer mount feed back), then it work. But all my parts go to camera will be off the oposite way.
Electronics Forum | Thu Nov 22 09:21:05 EST 2007 | hsodan
Hello, If somebody can point out few most important differences between those two models I would be grateful. We are shopping for used machine, but the spec's we get for both models are the same, the price not, even if comparing machines with similar
Electronics Forum | Mon Jun 07 15:54:56 EDT 2010 | thanh
ECLIPSE-II After calibration, now i'm having an issue that placement between lazer and camera off about .5mm on the Y mount. if parts go to camera, the placement are good. but parts that placing with lazer it off about .5mm at Y for all rotation. do
Electronics Forum | Sat May 29 02:20:08 EDT 2010 | vinitverma
Mch Adjust > Adjust Target > Laser Unit > Nozzle Position. Here the laser will automatically detect the centre of the nozzle. Remember - It'll give you the option of using a component for the test but DON'T use any component. Let it detect the centre
