Electronics Forum | Sat May 14 17:25:20 EDT 2005 | fastek
"What can be done to create economical advantages over here is review the product flow and eliminate process steps with current existing technology. Process steps that can safely be eliminated are cleaning, visual inspection, post wave assembly etc.
Electronics Forum | Fri Feb 18 16:08:35 EST 2000 | ScottK
John, As a supplier of squeegee blades, we ship them out in clear plastics tubes at the approximate length of the blade itself. The ends of the tube have simple slide-on end caps. After visiting many customers sites, I've found that most of them k
Electronics Forum | Thu Mar 16 09:01:28 EST 2000 | Ashok Dhawan
I am looking for suggestions on " How to remove solder Balls". We have some designs and tools where nothing can be done economically except to remove the solder balls manually. We are using "Probe" picks to do that job. Anyone who can suggest a bet
Electronics Forum | Fri Feb 18 16:08:35 EST 2000 | ScottK
John, As a supplier of squeegee blades, we ship them out in clear plastics tubes at the approximate length of the blade itself. The ends of the tube have simple slide-on end caps. After visiting many customers sites, I've found that most of them k
Electronics Forum | Sun Jan 23 17:20:11 EST 2000 | Thomas Ravener
The most economical way is to look at each others web site and look at the co's that have pre-registered and the booth #'s they are registered to. This would be a non bias approach. This would allow you the opportunity to see if the co's that interes
Electronics Forum | Wed Dec 01 10:26:10 EST 1999 | Dick Casagrande
My company is in the process of determining whether to setup an in-house SMT line. We presently do thru hole assembly and subcontract SMT boards which are growing in number. The economics are not my main concern now. The intangibles, i.e., control, l
Electronics Forum | Fri Oct 15 11:37:21 EDT 1999 | Ashok Dhawan
I am looking for someone using Wanesco Soldering Station with hole blow-off option installed.I am trying to set it up using hot air. It is provided with special tips with rubber lining to seal off the slected area. But it leaves few holes always bloc
Electronics Forum | Tue Sep 29 08:17:30 EDT 1998 | Jim Zanolli
Teka Interconnection Systems may have a connector with their Solder Flux Bearing Lead technology -- by an economical pre-deposit of solder and flux on each connector lead, the connectors can be reflowed in convection with other SMD's without adding s
Electronics Forum | Wed Sep 05 14:32:32 EDT 2001 | Michelle
Hello! You are all so witty and extremely amusing. This is my first note in and, um, plug. I do have a system that is highly effective, environmentally-friendly and economical(cheap) for those of you who are interested. Also, yes, we do offer tha
Electronics Forum | Sat Oct 20 09:19:24 EDT 2001 | davef
"Phased out" is not the correct term. " Not economic" might be more appropriate. Check: R&D Technical Services (Centech) 12261 Suite A Nicollet Ave S Burnsville, MN 55337 (612) 707-1931 fax 6739 sales@rdtechnicalservices Further, Graham Naisbatt
