Electronics Forum | Wed Jan 26 16:51:18 EST 2000 | Casimir Budzinski
I am using kester 958 no clean in an Electrovert Econopak 2 and having trouble with white residue, the solder pot has a foam fluxer and I have tried diferent setings on the air knife angle & pressure, the top board temp is aprox 200F.Any help would b
Electronics Forum | Wed Dec 21 06:51:48 EST 2005 | aj
Hi all, I have an Electrovert Econopak Plus wave solder machine. Lately the solder pot temp has been fluctuating +/-10 degrees c. I have replaced the thermocouple as I suspected it to be faulty but the problem still exists. I am confident that the
Electronics Forum | Mon Dec 12 13:34:15 EST 2005 | jbrower
Hi Frank I use an electrovert econopak and am very pleased with it. Electrovert offers a leadfree upgrade to the pot but it is a might bit expensive. Contact them for pricing. In my machine I am going with SN100 distributed by AIM. It might be some
Electronics Forum | Fri Feb 04 09:17:30 EST 2005 | Steve Gregory
I have a need for two heater element/strips for the pot of a Econopak EPK+ Type 400F. PN 3-0606-793-01-2. I was told it would be 2-3 weeks from Electrovert. If anybody knows of where I might get them quicker than 2-3 weeks, I sure would appreciate it
Electronics Forum | Fri Apr 28 13:23:22 EDT 2000 | Chris McDonald
We have had nsome new products come in that require Bottom side wave soldering (SMT). I have SOIC's 1206, 0805 that are Glued then Wave soldered. I have had trouble with bridging and no-clean residue with these pcbs. I have a Econopak 2 SMT two zone
Electronics Forum | Thu Apr 16 09:31:28 EDT 2009 | padawanlinuxero
Hi all! I have a problem, I have a wave solder a Econopak plus by Electrovert, and someone move something when I was not here, now when I try to load a recipe a very specific recipe is givening me a error message : MyrecipeName Isam error 30000: Da
Electronics Forum | Tue May 02 17:11:17 EDT 2000 | John
My company just purchased a Vecta (E-vert) wave soldering machine. Bridging has become a serious issue, both on SMT components and thru hole. We are currently seeing about 500 ppm. The products that are being run now were run previously on our old
Electronics Forum | Tue Jan 17 10:09:03 EST 2006 | pjc
I will send an engineering data sheet to your e-mail address. I do not have a manual, check with these guys: Tom or Dennis (603) 437-4755 Ed Fortuna (603) 759-2953
Electronics Forum | Mon Jul 05 03:14:47 EDT 2004 | P.V
I am looking for the solder pot size on the above wave machine, any help would be appreciated
Electronics Forum | Tue Jan 17 10:00:19 EST 2006 | alandra516
Contact me I have both mauals that you need glenn@alandraservices.com
