Electronics Forum | Tue Jun 01 15:09:58 EDT 1999 | Tony
| Dear All, | | We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out of the follow
Electronics Forum | Wed Jun 02 04:04:58 EDT 1999 | Vinesh Gandhi
| | Dear All, | | | | We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out of the
Electronics Forum | Fri Feb 04 09:17:30 EST 2005 | Steve Gregory
I have a need for two heater element/strips for the pot of a Econopak EPK+ Type 400F. PN 3-0606-793-01-2. I was told it would be 2-3 weeks from Electrovert. If anybody knows of where I might get them quicker than 2-3 weeks, I sure would appreciate it
Electronics Forum | Tue Jun 01 07:17:00 EDT 1999 | Vinesh Gandhi
Dear All, We are a medium sized sub contract manufacturing house, engaged in high mix, medium volume production. We are using no clean as well as Aqueous cleaning process. we are planning to buy a new wave soldering machine out of the following op
Electronics Forum | Fri Jul 10 12:22:37 EDT 1998 | Ben Salisbury
| We are looking for spare hard drives for the Fuji MCS computer. I believe this is an MFM drive. Is this correct? Where can these drives be found? | Thanks. I was going through the archives and came accross this one...no answer...probably too lat
Electronics Forum | Tue Jan 20 21:37:26 EST 2004 | alwil
I am looking for a supplier or a manufacturer who can help me with Titanium Fingers for our Electrovert Econopak Plus wave solder. I am looking for the "v" groove type and also the 90 degree type fingers. I am in Australia. Thanks.
Electronics Forum | Tue Nov 28 14:02:06 EST 2006 | jsloot
I am starting to use a DATAPAQ wave analysis software on our Econopak EPK II machines. I would like to know what values you may be using for alarm conditions. I can email an example if you can help. Thanks
Electronics Forum | Wed Jan 26 16:51:18 EST 2000 | Casimir Budzinski
I am using kester 958 no clean in an Electrovert Econopak 2 and having trouble with white residue, the solder pot has a foam fluxer and I have tried diferent setings on the air knife angle & pressure, the top board temp is aprox 200F.Any help would b
Electronics Forum | Tue Jan 17 10:09:03 EST 2006 | pjc
I will send an engineering data sheet to your e-mail address. I do not have a manual, check with these guys: Tom or Dennis (603) 437-4755 Ed Fortuna (603) 759-2953
Electronics Forum | Tue May 07 10:32:13 EDT 2002 | Todd M. Troyer
Does any one know where I can get after-market preheaters for an Electrovert Econopak II SMT wave?
