Electronics Forum | Tue Nov 20 18:56:19 EST 2018 | dekhead
If always on... you will need to write product file as edge justified, and position stencil properly before auto-clamping takes place. If always off... you will need to write product file as center justified... and position stencil and acknowledge st
Electronics Forum | Wed Nov 21 00:14:25 EST 2018 | leeg
As Dekhead has said, sounds to me like you have the wrong setting in your screen choice within the program, is it edge or centre justified?
Electronics Forum | Wed Jan 22 11:18:26 EST 2020 | emeto
It is all PCB design based for me. Auto router is great as you can pick tabs locations to avoid stress on components close to the PCB edge. For some boards you can hardly justify anything other than manual V-score. So I would say there is no better w
Electronics Forum | Sun Apr 25 04:34:09 EDT 1999 | Earl Moon
No this message isn't about my triumphant return. It's not even about that lady I wanted to run away with to Mehico (who were you again). It's about progress and some of you might be interested, or not. 1) For DEKheads, I submit we had two of Britai
Electronics Forum | Sun May 04 19:18:42 EDT 2008 | dman97
Hi all, I recently acquired a year 2000 dek 265 horizon. It has a manual screen loader with that stupid hand crank adjustable stopper. Can anyone tell me how I am supposed to measure the stencil image dimensions for a front justified stencil? Now on
Electronics Forum | Fri Oct 25 14:46:50 EDT 2002 | russ
Leading edge, This is used to determine the orientation of the board as you want to run it. If you use center justified stencils this is usually not an issue since you can just turn the stencil any which way you want to. If you are using front/rear
Electronics Forum | Fri May 08 08:12:32 EDT 1998 | Steve Gregory
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Wed Mar 21 10:30:15 EDT 2007 | ck_the_flip
Chrissie also says, "Before anyone suggests it - redesign of the boards is not an option!!", so I'm assuming that re-design means panelization too. She's probably sitting on thousands of these unpanelized PCB's in stock. Now, for the future, as Ste
Electronics Forum | Thu May 07 12:29:17 EDT 1998 | Rob Williams
I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am h
Electronics Forum | Fri Sep 15 15:51:53 EDT 2006 | MFG CAVEMAN
We have a new product that uses an SMT edge connector. The process we are using is as follows: -Screen print side 1 (no paste on connector pads) -Place Rs & Cs -Reflow -Screen print side 2 (paste on connector pads) -Slide connector into side 2 wet
winsouce.jpg)