Electronics Forum | Mon Nov 09 15:44:39 EST 2020 | mikewschomisch
DEK 265LT displays CMOC is BAD: Restoring from EEPROM.... EEPROM is BAD: No Restore was made. You MUST run SETUP followed by LOCKMOS... FAILED Any help appreciated.
Electronics Forum | Wed Nov 25 11:30:56 EST 2009 | rajeshwara
PRODUCT : SET TOP BOXES PROBLEM : Flash Programmed IC ( EEPROM ) Data Corruption. Description : Flash IC Data get corrupted during testing or manufacturing. What is the possibility ? Plz Help.
Electronics Forum | Tue Nov 10 19:31:09 EST 2020 | mikewschomisch
I have been able to manually enter CMOS info in SETUP thanks to suggestions from this forum and get past the CMOS and EEPROM failures. Now stuck "diskette error". Any key will produce the same message. Thanks.
Electronics Forum | Tue Nov 10 19:46:13 EST 2020 | dekhead
Still t issue if yu remove FDD from boot sequence?
Electronics Forum | Wed Nov 11 03:36:10 EST 2020 | dekhead
Assuming you have defined HDD correctly (this is a non-standard CMOS setting), unless it is a totally dead HDD not the normal error for HDD failure. More inclined to think a CPU issue, I have not seen a "bad EEPROM" on that machine before... but pres
Electronics Forum | Thu Jul 28 03:38:39 EDT 2005 | Rob
Basically they are tiny EEproms powered by an induction loop. The EEproms or "Tags" store a unique identifier on them and can be read (or written too) by the small RF field generated by an induction loop reader from upto around a couple of feet aw
Electronics Forum | Sun Nov 27 05:07:15 EST 2016 | pmcg
Anyone, got a reply from UIC but $1k for an eeprom! Loaders will be junked in the new year if we can't get a replacement,
Electronics Forum | Wed Jun 24 21:58:16 EDT 2020 | kumarb
Thanks Rob. They want to sell us a new TDM which does not sound correct as the entire TDM is with an offset. Logic is making us believe that the calibrated data is stored inside the onboard microwire eeprom. Do not know the format of these expected v
Electronics Forum | Tue Nov 10 19:20:34 EST 2020 | dekhead
Can you manually enter CMOS information in Setup and boot from there?
Electronics Forum | Tue Nov 10 21:00:41 EST 2020 | mikewschomisch
I removed the ribbon cable from the FDD and edited the setting in SETUP to "NOT Installed";. Came back with 'Diskette drive failure on drive A'. on reboot. Still shows "Diskette error" on last line. Possible HDD issue? Thanks.
