Electronics Forum | Wed Nov 18 14:09:01 EST 2015 | davidgjessup
I am in need of a service manual for a Vitronics smr 500 reflow oven . If anyone has one that I COULD PURCHASE PLEASE SEND ME AN E-MAIL TO DAVIDGJESSUP@AOL.COM OR TEXT TO 317-358-7406
Electronics Forum | Wed Mar 16 14:03:09 EDT 2016 | simons
We are looking for a PDF of the manual for our 1088 EXL Heller reflow oven. Thanks
Electronics Forum | Thu Aug 24 01:01:23 EDT 2023 | frankchan
Is this a wave solder oven mate? Can't help with this one but we too are the manufacturer of Reflow & wave solder ovens and else. If related questions we can discuss about it and try to solve.
Electronics Forum | Tue Apr 12 10:18:31 EDT 2005 | Dan
I have one of these before our oven, and there is no way to control the speed of the belts. Checking their website produces nothing. We have the unit open, but nothing inside appears to be adjustable. Anyone know where I can find a manual for this? P
Electronics Forum | Wed Aug 03 16:58:19 EDT 2011 | pmdinc
We have a Surf Systems MPC 300 reflow oven that we are trying to keep going as we don't have the money to replace it. Does anyone have a manual or wiring diagram for this machine or one of its close relatives? We would be happy to compensate for th
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Thu Dec 03 14:40:27 EST 2015 | proceng1
When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LA
Electronics Forum | Fri Aug 19 14:01:02 EDT 2011 | davidalvarez
We just acquired an RO-260E reflow oven for doing prototypes and very small production runs, we are currently having issues with the conveyor motor. Before we got the oven the persons that had it before did some modifications to the conveyor system
Electronics Forum | Tue Jun 07 22:01:56 EDT 2005 | KEN
run shutdown.rcp after 45 minutes computer will load shutoff.rcp. Is this file not being loaded? If yes, then you have not defined the shutoff event in the scheduler. Poke around in the scheduler. Or check out the software manual. someone probab
Electronics Forum | Fri Jun 24 04:42:12 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon. What the practical air setting for all 10 zones + 2 coolig zone. This setting is to manually adjust on machine front right botton side. ajay
