Electronics Forum | Tue Nov 13 04:47:19 EST 2018 | dhammika
hi Siplace Hs-60 defected due to below error Error- • Machine error:2271 Can bus: reception call aborted with time out seg:0 DEV: head 2 #:1 (this is not only head 2 ,error raise with all head interm
Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Mon Jan 04 10:02:25 EST 2021 | djwave
Hi Aharper, We have an EKRA E5 too and starts to do this error "machine offline" like yours. I chequed like you say, the SMEMA ports, but seems all is good. You can send me the service Manual if you have it?, any clue on that error you can explain m
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
Electronics Forum | Wed Jul 24 10:57:32 EDT 2019 | aharper
We recently acquired an EKRA E5 (vintage 1999), and I am receiving a "Machine Offline" error. I discovered a cable labeled "X20b" that is disconnected, but I cannot find the port it should be connected to. I do have the manual but have not found any
Electronics Forum | Fri Jul 23 14:57:41 EDT 2010 | davef
On one hand, we appreciate your concerns. On the other hand, we agree that if you want someone to take ownership of the process, it really does make sense to have that person design the process. We think you should find a way to add to the process.
Electronics Forum | Sat Aug 26 03:18:15 EDT 2017 | ausplex
Mid-production our KE-730 halted and gave us a “SUB CPU1:BUS ERROR” message on the video monitor. Then we got on the same monitor a detailed error message with address and byte information (unfortunately I didn’t copy the details). Now when we boot
