Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c
Electronics Forum | Thu Jan 05 03:58:19 EST 2017 | rafaelnagares
Hello, I am having problem with the width of the conveyor and I suspect I need to calibrate this function. Do anyone have a Service manual? I have the operator and main software manual, but not service manual. Thanks a lot friends.
Electronics Forum | Thu Jan 05 04:03:56 EST 2017 | rafaelnagares
Hello, I am having problem with the width of the conveyor and I suspect I need to calibrate this function. Do anyone have a Service manual? I have the operator and main software manual, but not service manual. Thanks a lot friends.
Electronics Forum | Wed Jun 16 14:07:15 EDT 2021 | oxygensmd
For example, I had the same problem on my Rehm oven. It was in calibration mode. The machine is going to maximum transport width but sensor wasn't reached and the machine stucked in calibration mode. Maybe there are manual mode for transport width a
Electronics Forum | Fri Sep 02 21:34:35 EDT 2022 | dwl
Are they getting hung up transferring from one conveyor to the next? One thing we did was put a rounded chamfer on our PCB corners. I think it was a 1mm diameter. This stopped our boards from getting stuck. A few other random ideas to look at; Make
Electronics Forum | Thu Nov 19 10:12:38 EST 1998 | Brian Conner
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Mon Jul 17 16:29:18 EDT 2006 | aj
Rail widths are fine. The board loads from the previous conveyor and hits the down stop and flags the sensor... It will sit there and time out unless I flag the left rail sensor. It will work properly every now and again. All sensors work fine in t
Electronics Forum | Tue Nov 03 17:28:10 EST 1998 | smd
SMTnetters: My UIC conveyors aren't working with my: Omniflow 7 Reflow (Mfg 1/95) Dek 265 GS Philips CSM What can I do? Does anyone have experience with connecting UIC or other conveyors to the above equipment? On the reflow I jumped terminals 1
Electronics Forum | Fri Aug 17 09:42:18 EDT 2001 | Hussman
G'Day All, I have a couple of new Panasonic MSR's. Whenever I load a new program into the machine, I have to manually feed the first PCB onto the X/Y table to get it to run. After that, they run just fine. Panasonic is going to be in and they hav
