Electronics Forum | Wed May 15 11:07:45 EDT 2002 | slthomas
I've never had an E4 quoted (obligatory disclaimer), but I would expect them to be somewhere in the $90k-$110k range based on what they were quoting for E5's, plus whatever options you want. From what little I know about MPM's and DEK's, the EKRA's
Electronics Forum | Tue Oct 04 03:36:23 EDT 2016 | oxygensmd
Today we replaced the HDD to another one. The old HDD is in working condition that is why we can make a new copy-backup from that. We realized that the BIOS didn't see the HDD sometimes. Now we adjusted the BIOS to the right setup, replaced the batt
Electronics Forum | Thu Aug 03 10:13:41 EDT 2006 | wrongway
Hello Rush fan we have a Ekra E5 had it about a year the only thing I dont like is the foil on top of the doard holders you can take them off but if your board is warped then it dosnt clamp the board and it will fail the vision but we hav
Electronics Forum | Sat Feb 26 18:37:21 EST 2022 | oxygensmd
I am using SiPlace S20 and F4 machines. Both of them handle 0402 without problem. A newer machine, like S23 or S25HM is way better and accurate, S27HM can place smaller parts too. We are using EKRA E5 (2000) which can print this size without issues.
Electronics Forum | Tue Jun 06 13:38:27 EDT 2023 | spoiltforchoice
> It is really strange you don't have EKRA on your > list. EKRA are really good for protos and > mass-production too. We have E5, X5 and two > X4Prof. X4Prof are lasting forever if you handle > and maintenant them properly. ESP001
Electronics Forum | Fri May 09 16:30:47 EDT 2008 | wrongway
we had a 1995 dek 260 in 2005 we bought a ekra X5 these two machines wre not alike at all but our ekra has been performing very well for us we run at least 2 shifts 5 days a week. have had to change couple of switches and tighten a belt and a new po
Electronics Forum | Fri Jan 03 10:55:57 EST 2003 | slthomas
I'm not sure what you mean by "standard auto valve stem". Ours use EFD pumps to dispense fluid. I think there used to be a sort of a drip system that attempted to wet the entire length of the paper all at once but have never seen one. Which system
Electronics Forum | Mon Jan 06 11:04:39 EST 2003 | slthomas
Bummer. Are you using the EPAC stuff that they recommend, or something else? We used IPA for a while, then changed to a run-of-the-mill stencil cleaning solvent (aliphatic hydrocarbon based, like the EPAC solvent) that's a lot cheaper and does the
Electronics Forum | Thu Dec 18 19:15:56 EST 2003 | slthomas
I could probably have sold you a 2 year old E5 for about $35k a few months ago. I think they (two of them) are going to go the auction block now, and Ekra America may end up with them for a refurb. I'd call Steve Hall and ask him what they can do fo
Electronics Forum | Fri Jun 09 15:17:28 EDT 2023 | oxygensmd
I will sell my X5 soon, in September, as my scheduling comes true. Used EKRAs have really good price because they are good printers. I saw most of them between 4000-20000 EUR depends on configuration and vintage. My E5 was around 8k€ 10 years ago, X
