Electronics Forum | Mon Sep 29 15:28:29 EDT 2014 | dustin
After getting the last issue I had fixed through here. I thought I would try to see if there is a solution for another issue. I have and ekra e5 screen printer and it has a problem with the blades not dropping when they should. If I set up single dir
Electronics Forum | Tue Sep 30 14:06:16 EDT 2014 | nicodj77
Hi Dustin, It happened to us once and it was something very simple. We did maintenance to the Squeegee head and the problem was that the Squeegee head cover was not put back in place correctly, so it was interfering with the Squeegee up/down movement
Electronics Forum | Thu Oct 02 04:39:08 EDT 2014 | oxygensmd
I had the same problem with my E5. At first check the cover and valves in the squeegees head. For me wasn't help, I didn't found any fault, jamm. In my machine there is two adjustable valve over the transport at output-vent. I tried to readjust the
Electronics Forum | Sat Apr 09 00:37:42 EDT 2016 | smtsparescn
Are you sure it can work even somebody do clone the software and copy to you, Normally it isn't like adding a patch to windows of a pc,
Electronics Forum | Wed Mar 30 14:56:13 EDT 2016 | jsouth
We bought an ekra x5 at auction and the hard drive was pulled (due to the classified nature of the boards the company was producing)... i was told if i could find some one willing to make a clone of their hard drive (we are willing to supply the hard
Electronics Forum | Wed Jul 04 03:59:10 EDT 2018 | oxygensmd
I had similar problem before. I cleaned the PCs (both machine and station) and replaced the cooling paste on the CPU cooler. After time the Control was able to shut off - before the issue solved, we used the safety knob to cut the Control.
Electronics Forum | Wed Jul 04 04:04:19 EDT 2018 | oxygensmd
One more thing. We had a card defect during the control had this problem, on of TBF card burned out. But I think you need to check the thermal paste in the PC - clean the cooler and the filter first.
Electronics Forum | Fri Jun 29 03:49:26 EDT 2018 | seri09
Hi.i'm working with a screen printer EKRA E5 from 2001 and i have a problem with it. When i start the machine,the control option gets activated by itself and the CPU usage spikes to 100%. The machine works fine,but the problem is that i cannot turn o
Electronics Forum | Mon Apr 13 14:04:49 EDT 2015 | capse
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Up front qualifier, I'm the EKRA Rep for the southeastern US. I have been involved with stencil printers for abo
Electronics Forum | Wed Jul 16 11:30:32 EDT 2008 | slthomas
I *think* an E5 takes a 29"x29" frame and you might be able to find one in that price range. The trouble is just finding one. Ekra America will probably have refurbs but the price will no doubt be higher from them.
