Electronics Forum | Tue Sep 30 14:06:16 EDT 2014 | nicodj77
Hi Dustin, It happened to us once and it was something very simple. We did maintenance to the Squeegee head and the problem was that the Squeegee head cover was not put back in place correctly, so it was interfering with the Squeegee up/down movement
Electronics Forum | Thu Oct 02 04:39:08 EDT 2014 | oxygensmd
I had the same problem with my E5. At first check the cover and valves in the squeegees head. For me wasn't help, I didn't found any fault, jamm. In my machine there is two adjustable valve over the transport at output-vent. I tried to readjust the
Electronics Forum | Mon Sep 29 15:28:29 EDT 2014 | dustin
After getting the last issue I had fixed through here. I thought I would try to see if there is a solution for another issue. I have and ekra e5 screen printer and it has a problem with the blades not dropping when they should. If I set up single dir
Electronics Forum | Thu Jan 07 13:59:39 EST 2021 | djwave
Hi all, good news... resitting all stuff, CPU and cards...now EKRA return to live. Thx for clues.. Regards.
Electronics Forum | Mon Jul 29 10:04:08 EDT 2019 | griinder
I believe the x20 and x21 ports are used for smema. There is a proprietary smema end, that connects to those cables. They almost look like parallel port connectors right?
Electronics Forum | Mon Jul 29 10:21:38 EDT 2019 | aharper
Yes, they look like parallel port connectors. I traced the lines and I believe you are right about the SMEMA. Thanks for your input
Electronics Forum | Mon Jan 04 14:57:14 EST 2021 | aharper
I have found that doing a hard restart of the machine usually clears up the error. Aside from that, I have no insight into what is actually causing the error.
Electronics Forum | Mon Jan 04 15:57:38 EST 2021 | bobpan
I believe there are 2 computers in the machine. If i remember correctly its possible the other computer is stuck on something and its stopping it from booting up. Try to plug a monitor into it and maybe you will see an error.
Electronics Forum | Wed Jul 24 10:57:32 EDT 2019 | aharper
We recently acquired an EKRA E5 (vintage 1999), and I am receiving a "Machine Offline" error. I discovered a cable labeled "X20b" that is disconnected, but I cannot find the port it should be connected to. I do have the manual but have not found any
Electronics Forum | Tue Jan 05 07:01:37 EST 2021 | djwave
Hello, thanks for your replys. Our EKRA E5 only boots and use the front computer (old PC with MSDOS and software), the rear one always is off, dont start when i switch machine power, dont know if is required for operate the EKRA. We turned on the EK
.gif)
