Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Thu Jun 13 20:03:05 EDT 2019 | dekhead
Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?
Electronics Forum | Wed Jun 19 18:44:56 EDT 2019 | dekhead
Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.
Electronics Forum | Thu Jun 20 10:23:47 EDT 2019 | key
Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Jul 18 13:15:25 EDT 2019 | dekhead
I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.
Electronics Forum | Mon Feb 08 08:33:30 EST 2016 | claudea2
Hello, Our EKRA E4 goes off-line after this error message: Application error: SCB16 caused a General Protection Fault in module SBCDRV.EXE at 0011:10DD. Any ideas on how to troubleshoot this? It is running Windows for workgroup 3.11
Electronics Forum | Wed Feb 23 13:22:31 EST 2022 | micropak
Congratulations on being operational again... Few years ago, I acquired a Siplace line (S20 + F3 + S15 + G2) and I rebuild it completely because the line was lying idle for more than 10 years. All belts, pneumatic cylinders, pneumatic pipes were cha
Electronics Forum | Fri Apr 15 16:02:26 EDT 2005 | jdengler
ING, If my memory is correct: -This is from the large air cylinder below the X/Y table moving slow or not getting down all of the way. -The air cylinder has a sensor for when it's down all of the way. - This sensor could be bad but most of the t
Electronics Forum | Tue Mar 27 16:57:41 EDT 2018 | warwolf
You could try changing the SMC pneumatic cylinder? We had a few that needed them replaced, we would get a pick error from them and the part would not be presented in the tape pocket (as if the tape doesn't push far enough to click over the ratchet s
winsouce.jpg)
