Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Mon Aug 31 11:52:28 EDT 2020 | inspiredmorris20
Hello Jon, I appreciate your reply, correct there are 2 red (24v) that control the main power and 2 blue (they control the power to the units operation keys ready, start, stop, reset, change feeders.) additionally there is a red jumper wire on the E
Electronics Forum | Fri Aug 28 12:46:04 EDT 2020 | inspiredmorris20
Greetings all, my cp45 pnp machine is down this morning, gives me the code 0002 (front EME switch pressed). operator said they did not E-Stop, reset the unit and reboot the S/W a few times. the code pops up as soon as the software loads. I can turn
Electronics Forum | Wed Jun 08 09:37:20 EDT 2005 | james
Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I
Electronics Forum | Wed Jun 08 12:04:34 EDT 2005 | james
Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I E-s
Electronics Forum | Thu Nov 15 11:03:17 EST 2018 | bobpan
When our older Ekra machines wont reference.....we will either try to e-stop it and then turn the control back on and reference it again....or turn the machine off and back on. I would check all the sensors on the machine and also try to reposition
Electronics Forum | Mon Sep 03 21:33:41 EDT 2018 | aemery
Jeff R, The "24VS" stands for 24VDC Voltage Switched; meaning that it is supplied under machine control and other things have to happen in the machine before 24VS is applied, in this case to KP1 coil. KP1 coil/contact is in place as part of the pow
Electronics Forum | Mon Jul 10 16:37:10 EDT 2006 | mac
Hi All, Lately we have been getting a humming noise which seems to be coming from one of the D-axis motors on the CP4. If it happens the Op. hits the e-stop and resets the machine which clears the noise and machine runs fine. Obviously there is a
Electronics Forum | Tue Sep 01 11:53:21 EDT 2020 | inspiredmorris20
bukas, Yes, as soon as the software loads it immediately throws a 0002 (front E-stop pressed) and will not come out of EMER mode until i stop, reset, ready, on the control panel. yesterday however it also threw a E100 I/O I/F board communication d
Electronics Forum | Wed Apr 28 10:32:19 EDT 2004 | vickt
This was not a automatic feature of the 4796 series HSPs. You can try to continue to reset-start the feeder crg after each component missing event,and slowly build the remaining placements, but at some point you will reach a dead end. My best advice
