Electronics Forum | Tue Aug 04 04:20:36 EDT 2020 | bangir
Hi Chris, It's arround +/- 2MM. There was a gap if running pcb with thickness 1MM. The PCB position below the rail table.
Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd
There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.
Electronics Forum | Tue Aug 04 22:26:38 EDT 2020 | cbeneat
So 1MM is the board thickness in your program?
Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd
Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Thu Aug 06 22:37:45 EDT 2020 | cbeneat
Try 2211. I honestly can't remember what this gets you into. But I used it years ago.
Electronics Forum | Sat Aug 08 06:43:17 EDT 2020 | oxygensmd
9060, service code 3560, engineer code (as I remember)
Electronics Forum | Wed Sep 23 08:33:05 EDT 2020 | Modmatrix
Hello to everybody! Do anyone have a operator and main software manual and Service manual? Please send it to me. Thanks ( sidewinderx@libero.it)
Electronics Forum | Tue Feb 28 22:32:38 EST 2023 | cbeneat
it looks like the table is in contact with the Y1 switch. If you can remove the cover, the motor is the R/H one. Turning the belt will move that side of the table. I'm going with the assumption that an X4 is close to an X5.
Electronics Forum | Fri May 09 16:30:47 EDT 2008 | wrongway
we had a 1995 dek 260 in 2005 we bought a ekra X5 these two machines wre not alike at all but our ekra has been performing very well for us we run at least 2 shifts 5 days a week. have had to change couple of switches and tighten a belt and a new po