Electronics Forum | Fri Dec 16 17:48:43 EST 2022 | kumarb
Hi. May I ask the factory default password used on the Ekra X4 printer for the PCB parameter changes? Believe it is some permutation of '4113' or similar. We had an accident recently with a drunk driver run through our building. In the process, lo
Electronics Forum | Mon Nov 15 13:23:28 EST 2021 | sosigguy
try doubling the operator password, that's how it is setup on our Ekra. eg. 2140 operator password, then service password is 4280
Electronics Forum | Tue Jan 28 13:12:40 EST 2014 | bestglobalsmt
Perfect. it worked! thanks!
Electronics Forum | Tue Jan 28 10:08:32 EST 2014 | bestglobalsmt
Chris the standard service password works but to change the board dims and fid locations i need "operator" password which I don't have.
Electronics Forum | Fri Dec 16 20:52:50 EST 2022 | cbeneat
Double it if you need the machine settings(9060), at least that works on X5's.
Electronics Forum | Tue Jan 28 10:36:39 EST 2014 | cbeneat
Have you tried 4530, again for the X5's this is our operator password. Good luck
Electronics Forum | Mon Jan 27 14:34:02 EST 2014 | bestglobalsmt
Does anyone know if there is a standard administrator password. I have the operator level password and also the Service password but i cannot log into the mid level where you teach a program. is there a way to reset this? or is there a standard one
Electronics Forum | Mon Dec 19 15:53:21 EST 2022 | kumarb
Thank you Chris. Did not know that till now. Found the default above password faster on this forum than factory support. Very much appreciated. Thanks again.
Electronics Forum | Mon Jan 27 15:06:16 EST 2014 | cbeneat
Try 2211, on the X5's this is reserved for inspector, but it may be what you're looking for.
Electronics Forum | Sat Nov 13 15:32:07 EST 2021 | markhoch
Anyone happen to know the EKRA Serio 4000 Service or Engineer password? We just had our printers installed, our primary tech is out of reach, and I can't get a response from the Emergency Tech Support Hotline. Thanks in advance!
