Electronics Forum | Fri May 15 14:50:40 EDT 2015 | emeto
My top 3 printers: 1.DEK 2.MPM 3.EKRA Top 3 ovens: 1. BTU 2. Vitronics 3. Heller or Electrovert
Electronics Forum | Wed May 30 17:49:40 EDT 2018 | tschoen
Hello, I have been tasked with getting an old E4 back on its feet, but have NO documentation (typical). If anyone knows where to obtain manuals for these printers. Willing to compensate for quality resources. Thanks, toms@theallpower.com
Electronics Forum | Wed Nov 17 06:52:18 EST 2021 | oxygensmd
We are using the following passwords on our E5/X5 printers. I read them from password file (pwd001.ini and pwd002.ini). Service: 9060 Supervisor: 4422 Engineer (programmer): 4530 Operator: 1234 Service: 2211
Electronics Forum | Sun Mar 13 12:45:12 EDT 2022 | poly
Do you have any idea for the Ekra (or any other printer, especially MPM) how many cycles it can do before you should look for a new printer? How used is too used? 1 millon? 2? 10?
Electronics Forum | Thu Feb 12 17:07:19 EST 2015 | magan
i found out what was the issue. driver card was bad so, that needs to be replaced. Thanks for support but i still need 'ekra x5' manual if someone carry, please email me. every day& now some other thing needs replacement and for technical understan
Electronics Forum | Fri Jun 12 11:31:53 EDT 2015 | ngineer
We purchased an Ekra X5 at auction a while back to replace our semi-automatic stencil printer. We bought it knowing the following: it was running when removed, it had no manuals, screen or keypad (as I've seen on other ones). I'm trying to put toge
Electronics Forum | Mon Oct 12 19:12:13 EDT 2015 | cusackmusic
Looking are "new" stencil printers. Have heard a lot of people like the Ekra. I see there are X5s, X4s, and X1s available all over the place. I can't figure out what the differences are. They seem similar, and are similar vintage. Any insight?
Electronics Forum | Wed Feb 03 09:34:43 EST 2016 | oxygensmd
He everyone, We have an Ekra E5 screen printer which is really nice machine I think. Now I'm looking forward a new squeegees set. I don't know the E-series and the X-series can use both squeegees? Are the squeegee holder the same on this two machin
Electronics Forum | Mon Mar 04 07:44:57 EST 2019 | vrasak
Hello, My EKRA X5 printer does not clamp the PCB. I would like to the manual any E4, E5 or X5. Hope hopefully it should give me some clue. Could you please send me the manual E4, E5 or X5? vrasak@cncroom.com Thank you so much, Weerasak.
Electronics Forum | Mon Nov 15 17:42:02 EST 2021 | kumarb
Did you get this straightened out? If not, reach out to IRV or RUDI - they have been great for the tech support of our Ekra machine. ASYS Group Americas Inc. 140 Satellite Blvd NE, Suite D, Suwanee, GA 30024, USA Tel +1 770 246 9706 Fax
