Electronics Forum | Mon May 13 08:31:48 EDT 2019 | robl
Do you have in line 3D Solder Paste Inspection machines? If not the 2D inspection on the SP710 is very slow & not a patch on Hawkeye from DEK. If print time is not an issue then it doesn't matter. I have had both types of machine, and personally pre
Electronics Forum | Mon Feb 23 12:22:32 EST 2004 | esoderberg
I have an MPM SPM and two Ekra E4 screen printers. I have always run them dry with vacuum. I am also using no-clean paste and have not had a problem. The volume I run per day on the machines is 4 - 6,000 bds
Electronics Forum | Wed Jul 04 03:59:10 EDT 2018 | oxygensmd
I had similar problem before. I cleaned the PCs (both machine and station) and replaced the cooling paste on the CPU cooler. After time the Control was able to shut off - before the issue solved, we used the safety knob to cut the Control.
Electronics Forum | Wed Jul 04 04:04:19 EDT 2018 | oxygensmd
One more thing. We had a card defect during the control had this problem, on of TBF card burned out. But I think you need to check the thermal paste in the PC - clean the cooler and the filter first.
Electronics Forum | Fri Nov 17 16:24:18 EST 2006 | billwestiet
I'm in North Attleboro, small world. To answer your question, you can deposit small dots of paste with a syringe. Kind of tricky work, and there are small stencil soluions out there fairly inexpensively. See http://www.minimicrostencil.com/ (I do
Electronics Forum | Wed Aug 03 10:22:27 EDT 2005 | davef
Ekra makes a printer than can do 25".
Electronics Forum | Fri May 23 05:32:18 EDT 2008 | muarty
Charlie, Anything would be better than using a benchtop printer. We currently run all DEK printers at the moment which are fine, but I've recently been looking into alternatives to the DEK and have been very impressed by the Excerra printer not only
Electronics Forum | Tue May 10 21:13:03 EDT 2022 | kumarb
We have an Ekra X4 that we purchased ages ago but the line was idle due to numerous SMT supplier faults including defective used feeders and other issues. Now all is working well and we may consider to upgrade to a current Yamaha or Juki RX-8. Doing
Electronics Forum | Mon Aug 02 11:16:02 EDT 2010 | dman97
Thanks for the answers guys. I knew it had something to do with the calibration menus. It had just been so long since I had to do maintenance to an MPM printer. I had been working with DEKs and Ekras for the past 6 years.
Electronics Forum | Thu Apr 04 16:38:51 EST 2002 | davef
Equipment companies like to talk about �accuracy� and �repeatability�. These measures provide limited information. Flaws of the measure aside, some printer companies have begun to report Cp. * DEK ELA: Cp = 1.33 @ �0.025mm * DEK 265: Cp = 1.6 @ �0.0
