Electronics Forum | Wed Jul 09 10:45:13 EDT 2014 | guts1872
Yeah, already checked interlocks.
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Thu Jul 10 19:26:21 EDT 2014 | guts1872
It looks like we did have an interlock problem. Maintenance re possitioned them and it seems to have cleared up our problem. For some reason when we close the door, it still wants to reset the Amp power, but if we wait for the all clear in the GUI be
Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Thu Jun 26 08:11:15 EDT 2014 | leemeyer
I have 2 Meridian 1010's sitting in the back of my shop. I also bought used and never was able to get them working reliably. I hope you have better luck. If you need any parts keep me in mind.
Electronics Forum | Mon Jun 30 14:44:05 EDT 2014 | guts1872
Haven't had a chance to check this out yet. It ran all day Thursday with no trouble, then we were off for 3 days. Doing a changeover now so will try this next time it acts up. Thanks for your reply.
Electronics Forum | Wed Jul 09 11:00:47 EDT 2014 | guts1872
PC : A3005 I2 8 3326 Can anyone make sense of this?
Electronics Forum | Wed Jul 09 11:06:58 EDT 2014 | guts1872
PC : A3005 I2 8 3326. Can anyone make sense of this? Trying to add attachment but can't seem to get there.
Electronics Forum | Wed Jul 09 12:23:45 EDT 2014 | guts1872
We have cleaned the encoders even though they look pretty clean. The function clear doesnt have any effect on the machine while it is in this state. Have not checked the mag tracks but will give it a look.
Electronics Forum | Wed Jul 09 05:06:52 EDT 2014 | bobpan
Are you sure you don't have a door interlock problem? Some of the covers of mirae machines have a physical switch and a magnetic switch that both have to be made for the interlock to be closed. It could be if you have a magnetic switch that the magne
