Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | Thu Jul 27 12:12:02 EDT 2000 | JohnW
Wilson, I'm sure both Electrovert (electra?) and Soltec have machines in their rangs that will open to this size... Out of interest...what type of board is it?
Electronics Forum | Thu Jul 20 15:37:53 EDT 2000 | Tekguy2000
These parts are flat chip resistor arrays that have 4 end terminations on each side. It looks liek an IC but is typically in an 0805 and 1206 package type with convex terminations. .031" pitch from termination to termination and .011" spacing between
Electronics Forum | Thu Jul 13 04:01:02 EDT 2000 | JohnW
Dave, Firstly..how the heck are you?..been a while.... Ok so I'm running an Electrovert Electra witha hot gas knife, & I've got large server boards going over the wave. I've seen us loose chip, mainly Tants on the hot gas knife...ain't good especia
| 1 |
