Electronics Forum | Thu Sep 18 11:07:39 EDT 2003 | donbell
SR. Tech: I have worked with Omniflo 7 and 10 ovens for many years. I purchased several 10 zone ovens in '98 when I worked for Ericsson. Here are some of my experinces with Electrovert Omniflo ovens; Yes, you can expect to run the conveyor speed a
Electronics Forum | Tue Jan 03 11:52:10 EST 2012 | daxman
Hi Everyone, I'm looking for a maintenance manual for an OmniFlo 10 oven. Please let me know if you can help me out. Thanks, Dax
Electronics Forum | Thu Apr 15 08:55:36 EDT 2004 | russ
It could be possible that you have some gears or the clutch is slipping when the oven gets warm.
Electronics Forum | Fri Apr 16 11:34:35 EDT 2004 | pjc
possible problem with mechanical interface with encoder to shaft?
Electronics Forum | Thu Apr 24 16:34:18 EDT 2003 | pjc
OmniFlo 10 Engineering Data Sheet has been sent to your SMTnet mail box. Its a PDF 818Kb.
Electronics Forum | Thu Apr 15 16:37:15 EDT 2004 | wgaffubar
I agree with the loose parts but you can also put a O-scope where the encoder output goes into the computer to see if the signal has a lot of noise. A noisy signal can sometimes fool the input card into thinking the encoder pulses are ok.
Electronics Forum | Wed Jun 10 01:21:40 EDT 2009 | mikawi
So I got to work today. They asked me to finish removing all the parts for the CBS (center board support). While doing this I removed A Tor Tender tolomatic 1/2 inch gear box from the shaft that widens the rails. It is used to link the front and rear
Electronics Forum | Thu Apr 15 23:13:29 EDT 2004 | pyro747
What we are finding that the volts on the Drive motor are dropping when the oven gets hotter. As for the encoder not pick up the drop in speed, I ran the wires for the encoder outside of the oven away from everything, didn't help!!! I swapped PC's
Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer
A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
