Electronics Forum | Wed Sep 12 03:52:45 EDT 2018 | shascoet29
Hi, Is the IPC-A-610 applicable to CSP assemblies? Especially regarding the solder ball to solder ball distance versus the minimum electrical clearance for assembly(0.13mm/IPC-A-610). With a 0.4mm pitch component and 260 microns diameters balls, thi
Electronics Forum | Thu May 26 21:04:04 EDT 2005 | thaqalain
What is electrical clearance?
Electronics Forum | Fri Aug 26 17:27:48 EDT 2005 | saragorcos
Hello there, Most probably, since the solder balls are entrapped, it is a process indicator, but refer to IPC 610-6.5.3.1 on Excess solder / solder balls / splashes - it really depends on what class you are manufacturing, and the minimum electrical c
Electronics Forum | Fri Apr 12 17:22:47 EDT 2002 | davef
First, splitting hairs on parlance. * Conformal Coating. A thin electrically nonconductive protective coating that conforms to the configuration of the covered assembly to provide environmental and mechanical protection. * Solder Mask. Coating mate
Electronics Forum | Thu Jan 31 13:01:33 EST 2013 | kmots15
Defect if its not coated. Defect - Class 1,2,3 • Solder balls are not entrapped, encapsulated or attached or can become dislodged in the normal service environment. • Solder balls violate minimum electrical clearance.
Electronics Forum | Wed Jan 01 22:19:33 EST 2020 | sssamw
Solder ball attached on solder joint without violation minimum electrical clearance is acceptable. If your process parameter including stencil not changed, suggest you check if solder pasted being pushed out after IC placement, also check if solder j
Electronics Forum | Mon Jan 25 13:56:45 EST 1999 | Parvez Patel
Chang Hong while developing our CSP rework process, we found a temperature spread of about 130C at a distance of approx 150 mils from the component edge. our nozzle had about 20 mils clearance from all sides of the component being reworked. depending
Electronics Forum | Tue Jan 05 15:36:53 EST 1999 | Earl Moon
A question for you all! Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. My question concerns cleaning under, through, and around tight spaces. Way back when, we could not clean under 20 mil pitch
Electronics Forum | Tue Jun 06 11:57:12 EDT 2006 | Chunks
IPC 610 says acceptable Class 1 (Class 2, 3 indicator) if they are entrapped/encpsulated balls within 0.13mm of lands or pads. or exceed 0.13mm in diameter. Defect Class 1,2,3: Solder ball violates min electrical clearance. Solder balls not entrap
Electronics Forum | Mon Jul 16 15:49:33 EDT 2001 | Steve
The solder balls you are talking about are caused by too much paste. Reduce the size of the stencil aperatures. Concerning removing the solder balls, the first thing you need to ask yourself is, do I need to remove them. IPC-610, 12.4.10 states, "Ac
