Electronics Forum | Tue Dec 02 07:56:40 EST 2008 | realchunks
Wow, rocket science with Nasa specs! I like it. I don't see the trick question here, so I'll continue.... IPC simply states over hang of round or flattened (coined) leads is acceptable (class 1, 2, & 3) if it "does not violate minimum electrical c
Electronics Forum | Tue Dec 31 02:04:19 EST 2019 | sssamw
From the picture, I cannot see clearly solder ball violate electrical clearance or cause a short, maybe it is. What I can see is the solder paste has some misalignment although it doesn't printed in solder mask area, but actual position will reduce
Electronics Forum | Tue Jun 29 14:42:55 EDT 2004 | davef
You're correct, for every dumpster full of paper written about solder, there's a sentance written about fluxes. There's dribs and drabs about fluxes in most of the soldering books [ie, Manko, Klein-Wassink, Judd, Strauss, etc] and most of that is ve
Electronics Forum | Thu Dec 31 01:09:18 EST 1998 | Kelvin Chow
Dear Micheal, SIR test is used to characterize fluxes by determining the degration of electrical insulation resistance of rigid printed wiring board specimens after exposure to the specified flux. (IPC TM-650 #2.6.3.3 http://www.ipc.org/html/tm2.6.h
Electronics Forum | Thu Dec 31 14:20:35 EST 1998 | Michael Allen
Kelvin, Yes, we're referencing the same spec. I performed the test under the Class 2 conditions (except that I used a 100V bias rather than 50V...but my water-washed microBGAs still passed). Regarding the omegameter test: we have this instrument,
Electronics Forum | Mon Jun 11 22:00:19 EDT 2001 | davef
IPC-A-610 uses words to the effect that it�s a Class 2 process indicator, if either: * Entrapped or encapsulated solder balls that are within 0.13 mm [0.00512 in] of lands or connectors, OR * Entrapped or encapsulated solder balls exceed 0.13mm [0.00
Electronics Forum | Thu Feb 19 15:17:52 EST 1998 | Bipin Napal
Available immediately. Call Bipin at 416-385-0855 Make: Electrovert Model: 500 CLV Electrical: 440V, 3Phase, 60HZ Manufacturing Date: Dec 22, 1992, and upgraded in 1994 Physical Size: Length 205.5�, Width 55� Heating Zones : 10 Upper & 10 Lo
Electronics Forum | Mon Aug 31 16:23:37 EDT 1998 | Bill Boles
We have an unusual problem here and I'm reaching for more input if anyone can help??? We are an OEM manufacturer of PCA's. After a history of consistent quality designs, we have one small memory SIMM that is causing major headaches for us and our PCB
Electronics Forum | Fri Oct 25 12:23:49 EDT 2002 | yngwie
Hi Experts, I'm facing short problem with BGA at SRT rework in one particular BGA. It is BGA, with a metal piece at the center like a coin. The BGA is located in between two high profile press fit connectors and the short always observed at the si
Electronics Forum | Tue Nov 19 21:38:39 EST 2019 | zack
Hello, The first thing that you need to do is to make process mapping about this incident, so you can exactly determine all factors and observable changes happened during 2 weeks of timeline difference. According to my experience, if all equipment
winsouce.jpg)
