Electronics Forum | Thu Jan 21 15:24:18 EST 1999 | Terry Burnette
| I have received prototype PBGA (256 pins) devices from | Motorola (actual part number = KXPC850ZT50). These parts seemed very warped on the edges. When I put the part on a plain surface, it rocks quite a bit when I press lightly on a corner. I h
Electronics Forum | Thu Aug 06 13:18:30 EDT 1998 | Bob Willis
| | Is there any problem using SMT on gold boards? 15 years ago we were told not to use gold boards, but I can't remember why. Judging by the other postings it now appears to be common. Only problem I see is that the nickel should be plated, not e
Electronics Forum | Mon Aug 28 17:04:52 EDT 2006 | Board House
ImSn - Immersion Tin - Not Recomended- short shelf life ImAg - Immersion Silver - Prefered Surface finsh by most Board houses, Best reworkablility, 12 moth self life, ENIG - Electroless Nickel Immersion Gold - Second Choice for Board Shops, 12 -
Electronics Forum | Tue Aug 31 12:42:45 EDT 1999 | Charles Barker
****************************************** ***************** HELP! *************** ****************************************** We are having a special ceramic smt board made. The boards are 16-up arrays that have smt pads on both sides. Only thre
Electronics Forum | Wed Feb 03 16:45:20 EST 1999 | Mark Henebry
Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connector
Electronics Forum | Thu Jun 01 21:54:00 EDT 2000 | Dave F
Jeremy: Standards: � A-600 talks about percentage of solder mask loss allowed, according to the location (eg, laminate, bare copper, gold or nickel, melting metals) and equipment class. � A-610 talks to "Solder Resist Coating - Voids & Blisters" by
Electronics Forum | Thu Sep 30 10:14:33 EDT 2004 | davef
USING CONDUCTIVE EPOXY: Epoxies do not bond well to tin or tin alloy surfaces. * For components: a silver-palladium or gold end termination is recommended. * For substrates: gold over nickel should work well. Remember epoxy is not hermetic, and ox
Electronics Forum | Sun Nov 21 21:40:13 EST 2004 | John
I'm experiencing an impedance breakdown on an 0805 ceramic cap. In the application, the cap is at a 16V bias at all times. The unit failed in an extremely high humidity condition. We are using a NC flux and have determined there was flux underneat
Electronics Forum | Sun Aug 08 11:15:32 EDT 1999 | Earl Moon
| | Mike, | | | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no goo
Electronics Forum | Fri Jun 18 13:48:37 EDT 1999 | Earl Moon
| We currently use HASL on all of our boards and I would like to move to something else. I have sampled some boards with Entek OSP and I loved it, the problem is we have plated mounting holes on just about every board we make. Does anyone have info
.gif)
winsouce.jpg)
