Electronics Forum | Tue Nov 29 21:51:37 EST 2005 | wmeyers
I have a pin and sleeve assembly that utilizes a fusible link type of solder, Bi, Cd, Pb and Sn alloy. The pin is gold plated, the sleeve is copper alloy 725. I have had sporadic success with wetting of the sleeve during the reflow process. To improv
Electronics Forum | Tue Nov 29 22:32:51 EST 2005 | davef
The dissolution rate of nickel into tin is a lot slower than that of copper [into tin]. This results in a nickel-tin (Ni3Sn4) intermetallic that is only 0.25-0.75�m thin after a normal soldering process. The Ni-Sn intermetallic compound tends to be m
Electronics Forum | Tue Apr 22 08:55:54 EDT 2014 | davef
I assume that you're talking about wanting to solder to metal tabs that are spot welded to the battery terminal. These tabs are not meant to be soldered. The metal was special selected for welding. In the old days, you could buy plumbing flux at th
Electronics Forum | Wed Apr 21 17:08:32 EDT 2004 | dave
Congratulations on your new customer. This could be a keeper. Here's what you're familiar with: Electroless Nickel - per MIL-C-26074 and ASTM-B733. Electroless nickel describes the plating of nickel deposits, which may contain phosphorus and boro
Electronics Forum | Tue Aug 20 14:55:33 EDT 2002 | markhoch
Has anybody expierianced solderability issues on electroless nickel boards that do not have gold immersion? We recently tried to process boards of this type, and I may as well have been trying to reflow on plastic. Any ideas?
Electronics Forum | Tue Feb 22 09:01:50 EST 2005 | davef
It could be that you're starting with hyper corroded nickel, before you even begin work. With electroless nickel, everybody looks at the nickel, but the cause turns out to be the immersion gold is too aggressive [during fabrication]. Immersion gold
Electronics Forum | Wed Aug 21 17:43:12 EDT 2002 | davef
Your flux supplier will have good suggestions.
Electronics Forum | Fri Aug 17 11:55:31 EDT 2001 | davef
5uin. Your nickel thickness is fine. Although if you wanted to trade costs, consider giving-up nickel to 150uin thickness, while increasing the gold thickness. Gold over electroless nickel creates brittle joints because of phosphorous in the nicke
Electronics Forum | Fri Aug 07 07:52:15 EDT 1998 | Earl Moon
| | Is there any problem using SMT on gold boards? 15 years ago we were told not to use gold boards, but I can't remember why. Judging by the other postings it now appears to be common. Only problem I see is that the nickel should be plated, not e
Electronics Forum | Fri Sep 21 10:35:37 EDT 2012 | davef
Flash gold is just thin electrolytic gold plating over electroless nickel or electrolytic nickel. Flash gold plating ... * Less than 3 microinch thick will be porous and take solder poorly * Greater than 10 microinch thick will cause brittle solder c
.gif)
.gif)
