Electronics Forum | Thu Mar 10 04:12:01 EST 2005 | aj
Guys, I have a Dek Mk1-similiar to 265. I am having some intermittent problems with the Camera. The signal gets all fuzzy every now and again, by me disconnecting the power and reconnecting it works fine again . They are quite expensive to replace
Electronics Forum | Thu Mar 10 08:29:53 EST 2005 | jdengler
AJ, Dek recommended the replacement of the wire harnesses on the Mk1's often (I think anually). I never saw this problem on a Mk1 but many other odd problems due to breaks in the wire harness. They had this as a kit at one time but I haven't worke
Electronics Forum | Thu Mar 10 10:06:08 EST 2005 | steve
OK all you Gurus here's one for ya. Customer is tinning wires with standard eutectic solder in a solder pot. There is a blue tint to the solder in the pot. After tinning with OA flux, which I will change to NC shortly, he has clear teflon insulation
Electronics Forum | Thu Mar 10 15:43:06 EST 2005 | steve
Thank you both for your assistance. I knew that I could count on you folks. The customer has purchased No-Clean flux and is using it as we speak. Hows that for customer service.... All in a days work... Thanks again You make me look good!!! Steve
Electronics Forum | Thu Mar 10 12:46:17 EST 2005 | jimk
Does anyone have experience in N2 supply source for reflow oven (1000scfh) other than N2 generator? Tanks, liquid, etc. We are in the developement stages of lead free processing and would like a quick, short term solution for providing N2 to a Concep
Electronics Forum | Fri Mar 11 03:23:58 EST 2005 | py (france)
ken, in order to improve the wettability I suppose.... But it seems that jimk wants N2 for the reflow owen even if he does not need N2... ==== jimk: see air-liquide, linde gaz, and praxair , you can by N2 liquid in tank , or any other conditionnemen
Electronics Forum | Fri Mar 11 09:42:50 EST 2005 | cyber_wolf
If you are not getting repeatable transducer readings then some possiblities are : 1. Transducer is bad 2. Motor is bad 3. Y power booster Also, I can't remember if the Y motor has a flex coupling on it or not. If it does, check that out. Also, w
Electronics Forum | Fri Mar 11 11:19:02 EST 2005 | Steve C.
I would change the Quad Align cable. If you have a spare head board swap that out as well. Make sure your Quad Align lenses are clean. If the camera is smudged then you can have some problems aligning parts as well. Let us know what you find. Cheers.
Electronics Forum | Fri Mar 11 14:04:34 EST 2005 | Micheal
I changed both cables and still the same thing. I have not changed the quad align cable yet. Any other ideas. Also when I do a run pickup 1 it works normal but when I am in run mode forget it, the z-rod now dont even go all the way down.
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
