Electronics Forum | Wed Mar 15 17:13:21 EST 2006 | Wave Master Larry
Listen.I posted this same message on a diffrent thread but got no repsonse. Here's what im wondering Im more of a wave guy but we had a good employee in the engineering department, he's left the company but he used these setpoints on the ovens in a
Electronics Forum | Wed Mar 15 22:41:47 EST 2006 | KEN
Listen. I agree these "theeries" are suspicious and a complete waste of time. You should resist all attempts at change and do what feels right to you. Remember, when other scoff at you, ignore them. Just continue doing it your way. Your prowess an
Electronics Forum | Thu Mar 16 11:14:44 EST 2006 | Rob
Hi Jay, I'm guessing that you have either: a) heated length of 64 inches b) a zone temp of 230C and not a surface temp of this magnitude c) Burnt pizza's 8 mins at 220C for a perfect non frozen pizza, however I find that the thermocouples keep fal
Electronics Forum | Thu Mar 16 12:22:21 EST 2006 | stepheniii
Larry, I have said this on the forum > before. > > THE ONLY WAY TO KNOW IF OVEN HEATER > SET POINTS ARE CORRECT IS TO ATTACH THERMO > COUPLES TO YOUR PC BOARDS AND RUN A THERMAL > PROFILE WITH A DATA-LOGGING DEVICE! > > Anything > other than t
Electronics Forum | Tue Mar 28 19:34:50 EST 2006 | daxman
Hey Sr.Tech .. Thanks for you help with my CP6 problems by the way.. Did you just get this machine? We've had many initial problems with ours. Most of them were related to the air pressure settings. There should be 2 regulators on the back of the
Electronics Forum | Tue Mar 28 17:10:25 EST 2006 | mikecollier
I unfortunately cannot post any photos, the unit in question is classified. And, as far as my comment that the BGA profile can be manipulated, if an engineer is also working the process with one of the operators, they can override the profile at any
Electronics Forum | Tue Mar 21 21:03:55 EST 2006 | davef
1 Chatter about mask opening � No BIG problems with these statements. It�s just that you may need to tailor your reflow recipe to minimize these escapees. 2 Stencil design - Any area ratio below 0.66 is going to very challenging to print, as you ca
Electronics Forum | Mon Mar 20 03:47:16 EST 2006 | Adrian
Hi guys, Has anyone ever had experiance with a Vision Master 150 ?, we have 2 onsite and I am trying to get accurate BGA paste height measurements from this machine, but both the machines are giving me results with huge variations, like +/- 0.2 thou
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Thu Mar 23 09:29:58 EST 2006 | Joe
I agree that it's the probably the chain. The links get dirty and can bind up over time. When you pull the chain, check to see that each link rotatates freely with its adjacent link. I bet you'll find one or more links that are binding. This is the s
