Electronics Forum | Wed Feb 28 20:16:26 EST 2001 | mhunter
Checked the archives with no luck. Anyone have a reliable test method of verifying acrylic conformal coat cure. Using Humiseal 1B31 mixed with approximately 30% solvent, spraying with a Nordson. Thanks in advance.
Electronics Forum | Thu Mar 01 10:43:09 EST 2001 | camohn
Charlie When I post a message I want the authors name to be Charlie. What is displayed is camohn. Also the above 'Charlie' apperars in this massage box. I have edited the account info with no success. Please correct.
Electronics Forum | Mon Mar 05 13:05:23 EST 2001 | bdoyle
Hi Charlie, It looks like its displaying your display name on the listing but your username when you post. You're the only person that sees that. We've logged the bug though and will address it in our next bug sweep though. Thanks! Brian
Electronics Forum | Fri Mar 02 15:32:52 EST 2001 | jagman
We are seeing a white, powdery residue following the Wave process. Is this a solder masking issue (poor cure from the PCB mfg) or Wave process related? Any input is greatly appreciated.
Electronics Forum | Fri Mar 02 15:52:19 EST 2001 | jagman
This happens to be after the water wash process. These are Burn-In boards so an SMT epoxy is used prior to wave. The flux used is Kester 2331ZX. Would using a thinner cause this to occur? The residue is all over the board. Thanks.
Electronics Forum | Fri Mar 02 16:47:39 EST 2001 | traviss
If the thinner you are using is 4662 and the correct amounts that should not be the problem. Is this the first solder operation? I would start by looking for rosen or no clean flux getting on the boards at some point before wave soldering and not bei
Electronics Forum | Sat Mar 03 03:56:04 EST 2001 | wister
I had confused by same problem, the reason I found is the interval between wave soldering and cleaning is too long and did not set the temp. of D.I water at 120F~150F. Kester flux is good. Rgs, Wister
Electronics Forum | Tue Mar 06 13:59:39 EST 2001 | dason_c
I have experience to the Kester 2331 water soluble flux long time ago with white residue and it related to the solder masking. Check what kind of the solder mask and ask Kester to do the test for you. Rgds.
Electronics Forum | Sat Mar 03 09:48:27 EST 2001 | ghenning
Considering putting one of these into production. Any comments as to reliability, accuracy, programming ease, etc. greatly appreciated. Targeting small discretes (e.g. 0402), PBGA, CSP, & QFP (to 16 mil) Thanks in advance...
Electronics Forum | Wed Mar 07 09:29:36 EST 2001 | gsmguru
Enter A value of -1 in the Tray pickup X & Tray pickup Y fields. This will disable the automatic empty tray pickup by the machine. I would recommend getting a data sheet on the tray from the component vendor for accurate pocket & tray dimensions. Var
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835