Electronics Forum | Tue Apr 27 12:32:53 EDT 1999 | Frank Hinojos
What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? Thanks, Frank
Electronics Forum | Tue Apr 27 11:17:01 EDT 1999 | Ben Wilmot
Looking for a uk based company to tape and reel smt filters (small batch job). Any contacts appreciated. Thanks Ben
Electronics Forum | Tue Apr 27 08:13:28 EDT 1999 | wayne sanita
i am trying to design a stencil fixture for manual printing. has anyone done this before or has an idea? thanks
Electronics Forum | Tue Apr 27 06:35:33 EDT 1999 | Dan
Using moss fets attached to sub heatsink and hard coat anodizing sub heatsink at higher cost and erratic performance. Looking for thermal tape, insulator to replace hard coat that will prevent shorting.
Electronics Forum | Mon Apr 26 23:24:44 EDT 1999 | D Clement
Which is the preferred method for soldering a bga, adding solder paste or not? Solderpaste manufacturers say to add solder while the rework station manufacturer's say it's not necessary.
Electronics Forum | Tue Apr 27 14:55:37 EDT 1999 | Tony
| Has anyone used the APE SNIPER rework station for BGA packages? | I have not used it, but I have used the SRT and Conceptronics Freedom 2000 rework stations. Both are really good BGA rework stations.. Thanks
Electronics Forum | Sun Apr 25 17:36:45 EDT 1999 | Mohammad Yunus
Hi, Im doing some experiments and studies on lead free solders ( any alloys).I would like to get some information on a few lead free solder paste manufacturers and if possible their web page adress and contacts. Thanx in anticipation yunus
Electronics Forum | Fri Apr 23 12:59:18 EDT 1999 | Upinder Singh
Hi everybody, I would like to bench mark the quality out of our wave soldering m/c as far as DPPM levels are concerned. Can somebody provide me with some figures at their site or anywhere else for the same. Thanks Upinder ======
Electronics Forum | Thu Apr 22 16:15:17 EDT 1999 | Chris Jackson
I need to know if there are any special component pad designs that need to be considered when evaluating paste-in-hole? We have a few through hole connectors that are good candidates to place pre reflow. Does anyone have sugguestions. Thanks Chris
Electronics Forum | Thu Apr 22 15:24:40 EDT 1999 | KEM
Could anyone recommend a good depanization tool for a PCMCIA panel which has breakaways. For several reasons, we decided to go with this approach rather than scoring and I'm less than pleased with the punch presses we currently use. Any help will
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
