Electronics Forum | Fri Jan 07 09:03:44 EST 2022 | jineshjpr
Hi Everyone, I want to understand what is the copper thickness to be maintained in PTH Barrel hole. Is this same as Fab recommendation of surface finished copper thickness like 25/35/70 microns..??? Is there any specific IPC standards available to un
Electronics Forum | Fri Jan 07 16:30:53 EST 2022 | tey422
I have a quick question, what's the tallest (highest) SMT part you ever encounter? 1.5 inch or more? I have to set a depanel router's clearance height. It would need to recalibrate again every time if the spindle or camera's height is adjusted. There
Electronics Forum | Sat Jan 08 06:46:33 EST 2022 | jineshjpr
Hi anyone knows what is the minimum copper foil thickness available across the industries to make PCB surface. Intention is to achieve 23 microns of finished copper thickness in a 0.3mm thickness PCB. Ideally if 3 microns plates are available, additi
Electronics Forum | Mon Jan 10 03:48:15 EST 2022 | proy
Has anyone here got any innovated neat fast ways to quickly cut the end of an IC tube open clean and fast so that parts feed properly from a tube on a vibe (as best they can...) AND or any low volume easy to setup automated tube to tape and reel setu
Electronics Forum | Mon Jan 10 13:32:02 EST 2022 | proy
Yes you are correct on several points We do 3d print ends for tubes especially for tubes which have guide rails etc However the organization storage and finding when you need it is very difficult for any kind of tools for many people. Allen keys for
Electronics Forum | Sun Jan 16 16:51:23 EST 2022 | silverlead
Chapter 7 - Machine Control of the DEK manual outlines connectivity between the rising table servo node 6 and the NextMove ES card. If you don't have the manual, just PM me. I'm not an expert in DEK repair, but the solution could be as simple as clea
Electronics Forum | Fri Jan 21 12:36:52 EST 2022 | stephendo
Like I said a lot of people don't tape the gold fingers the first time they run them. After that they make sure the fingers get taped up because solder gets places you don't think it does and once it touches gold, that gold is contaminated. How do y
Electronics Forum | Mon Jan 24 11:17:30 EST 2022 | jineshjpr
Hi, Mainly concentrate on 2 subjects: 1- Cleaning of Misprinted PCB (always use best neutraliser to remove paste from PCB), 2- Underneath Stencil Cleaning - Use good stencil cleaner (rather than IPA) to wipe your stencil. Because both the above said
Electronics Forum | Mon Jan 24 11:07:30 EST 2022 | jineshjpr
Hi, In general Tantalum D & E case packages prefers 12mm Reel with sufficient height. Make sure that no external force has been applied to the reel ( where it causes pocket deformation) thus leads to prevent smooth component release. Slowdown the noz
Electronics Forum | Fri Jan 21 19:20:31 EST 2022 | SMTA-64304163
Can someone who designs IMS printed circuit boards advise us on how to document the materials on the drawing. We are looking for applicable specifications to reference along with the physical specs. The current design is 066 +/-.006. .059 al, .0028
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835