Electronics Forum | Tue Jun 30 17:47:57 EDT 2020 | rsatmech
Manual method is always risky. Evening with all sorts of scanning people are loading it wrongly. Below are the recommendations I have. (Kindly comment if anything don't seems to be a solution) 1) peer to peer check - once loaded check the value usin
Electronics Forum | Fri Jul 10 19:00:01 EDT 2020 | tristanlund
Its nice to have Qsoft on a 4c, its a lot more user friendly than the old system. but.. 1.It doesn't increase the machines accuracy 2.All of PPM's software is very buggy, We ended up switching all our Q machines back to Quad's windows 98 software fo
Electronics Forum | Tue Jun 30 11:29:37 EDT 2020 | stephendo
I don't the Omron but I have worked with one where if you taught more acceptable windows then over time the machine slowed down because it had to do more checking. On that machine a false fail could be added to the library. Over time each component c
Electronics Forum | Sun Jul 05 22:21:58 EDT 2020 | raoult
Hi, The micro switch is broken on my device, it was a tactile one (4mm) : image1, image2 Do you think I can buy another one and just solder it like this with 2 wires (I can't solder it back to where it was because it's too tiny I don't have the sk
Electronics Forum | Mon Jul 06 14:54:36 EDT 2020 | dwl
The pictures are kinda fuzzy so its hard to tell of the center pad is electrically connected to anything. If it's not, if its just here for mechanical stability, then you're probably fine. The other thing to make sure of is that both switches are th
Electronics Forum | Mon Jul 06 21:16:59 EDT 2020 | raoult
Thanks guys for your help. Sorry for the pic quality, the device is so small I had to zoom a lot with my phone. The switch is a tactile one, the plastic body is missing, and what you can see in the center is where the contact is made : when the swit
Electronics Forum | Tue Jul 07 14:56:47 EDT 2020 | jmelson
Yup, it does. One is laying on it's side on the back feeder rail, pointing outward, in the first picture. The other is pointing upward behind the vibe feeder on the front feeder rail, in the 2nd picture. Thanks VERRRRRY much for ID'ing these parts
Electronics Forum | Wed Jul 08 23:07:18 EDT 2020 | tylerrobertson
Hello, Trying to re-purpose a QUAD feeder for delivering small parts to a scada robot. Wondering if someone could help me out with a pinout for the connector. it's 8 pins Feeder is p/n 12/10-23959B SSA Was able to get the board to power up and flas
Electronics Forum | Tue Jul 14 15:26:06 EDT 2020 | dekhead
Not as straightforward a question as you might think... due to the multiple rail systems (at least 4) used on Europa. But what you seem to be describing is the single stage conveyor, which uses same belt as used on the GSX, and majority of Horizon /
Electronics Forum | Tue Jul 14 07:23:50 EDT 2020 | researchmfg
There is a misunderstanding that people think the IMC layer grows the thicker the stronger soldering strength. The IMC layer can be grown and distributed evenly at the interface location will be good enough. Once the IMC layer grows too thick and ove
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
