Electronics Forum | Wed Jun 24 14:10:01 EDT 2020 | stephendo
When I was looking into it previously it looked like you could pay a large fee and have your paperwork audited. I didn't find having auditors coming in and checking that you were actually following your paperwork. Having your ESD S20-20 procedures au
Electronics Forum | Fri Jun 19 17:09:11 EDT 2020 | jmelson
The Eclipse really looks like it would do everything I'm doing now very well. I'm not too clear on how well the laser/1D vision would work for QFN parts, but maybe it would be fine. The downside is I think these machines are now going to be hard to
Electronics Forum | Mon Jun 22 01:49:27 EDT 2020 | vinitverma
I too would advise against converting a 3-phase machine to single phase. Eclipse is a single phase machine and not too difficult to find! It's a rugged machine and people still use them. Orion too is single phase but faster and less accurate than an
Electronics Forum | Fri Jun 26 01:33:32 EDT 2020 | jmelson
> why not get an older essemtec or neoden? I > believe both run on 110V. Thanks so much for the Essemtec hint! Their Fox 1 really looks like it suits my needs! 18 mm component height, 50 um accuracy, small size, what's not to like? I'm go
Electronics Forum | Sat Jun 27 01:10:06 EDT 2020 | jmelson
> Finding one used could be <BR> > the first challenge, the Fox is a 2016 machine <BR> > the second issue will be the price. Yes, after some research I realized the Fox is a relatively new model, and is going to be o
Electronics Forum | Mon Jun 29 15:25:09 EDT 2020 | jmelson
Spoilt, OK, a good point in your message, what good is a machine with 15 mm component height capability if there are no feeders that support that tall a component! I hadn't thought about that aspect! (My Philips CSM84 is limited to 6.5 mm, and I r
Electronics Forum | Mon Jun 29 15:33:28 EDT 2020 | jmelson
WOW, thanks for the documents, this will REALLY help selection. It looks like I want the FLX2011CV, that makes it a lot easier to set up and not have to reach into the machine to load and unload boards. The machine footprint is really compact, 10 m
Electronics Forum | Mon Jun 29 16:03:24 EDT 2020 | spoiltforchoice
I certainly can on the Paraquda and I suspect the basic algorithms are the same. Slimmer annular rings such as you might get on a plated via hole don't always image quite as well but if for some reason it doesn't pick it up you should be able to inte
Electronics Forum | Mon Jun 22 16:34:14 EDT 2020 | stephendo
What I have seen used are belt driven roof mounted exhausts. There would be a drum fan that is driven by belt and motor. That way the fumes never go over the motor or the belt. We would have to replace the belt every couple of years or so but then it
Electronics Forum | Sun Jun 21 02:43:27 EDT 2020 | jmelson
I'm planning to upgrade my P&P. We had a local auction that included a Samsung CP45FV. I was able to download a NEO manual, it was very well written and the Samsung software looks just incredible for setup and programming the vision system. But, t
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
