Electronics Forum | Thu Aug 08 11:28:34 EDT 2013 | simplycomplex85
I found a manual for a slightly newer version of my machine and it explained some of the terms that I wasn't familiar with. That helped. Also it seems a slightly newer version of the YTV-2000 series has TH built right in. Mine just doesn't. I playe
Electronics Forum | Mon Aug 05 09:16:39 EDT 2013 | valeriusx
Greetings. I'm having some difficulties in configuring 2 old SIPLACE Placement Machines - 80S-15 and 80F-3. They are already installed, there are no errors on machines computers, but I can't configure connection between these machines and the line c
Electronics Forum | Sat Jun 07 13:46:43 EDT 2014 | ipdisplays
Hi All, I know that is thread hasn't seen activity in a year or so... I'm having a similar issue in configuring a line. I see that the IEC addr is called version in the real.ma file. This is not helping me since I apparently have two machines that
Electronics Forum | Sun Jun 08 16:31:02 EDT 2014 | ipdisplays
Prob totally screwed the pooch... Got more than a little frustrated with not being able to get the stupid software to do what I thought it should do, anyway figured maybe the IEC port was the problem - I have a couple of spare cpu cards, so I swapped
Electronics Forum | Thu Aug 08 15:47:07 EDT 2013 | joeherz
Shawn, Wow. This is a tough one. The part is a 1 pc where I'm used to seeing a 2pc. In our case, we have several assemblies using a 2 pc system (see Laird BMI-S-207-C and BMI-S-207-F). The "C" and the "F" stand for Cover and Fence. The Fence is
Electronics Forum | Thu Aug 08 16:18:22 EDT 2013 | horchak
Placing and re-flowing the shield is of course the most economical. But once the shield is placed and reflowed this all but rules out inspection test and rework. Reflow should not be an issue if you have a decent forced air convection oven. You may w
Electronics Forum | Tue Aug 13 06:23:51 EDT 2013 | mccabekev
We are running a Heller 1707 EXL reflow oven, but we have a temperature variation across the board. When the oven first comes up to temperature, the centre of the board is 10degC hotter than the inside rail which is a further 10degC hotter than the
Electronics Forum | Wed Aug 21 09:09:50 EDT 2013 | wcheew
I am having solder barrel fill issues on THM component, we follow, we follow IPC 610 E requirement. The barrel fill issues happen on signal & ground pin at connector & E-cap. I found out that most of the insufficient solder happen on the connector ag
Electronics Forum | Thu Aug 22 13:31:23 EDT 2013 | bvdb
Re-doing this thread as original seems to have been shortened. Our beloved 24 year old Fuji IP-1 fine placement machine won't start. Has been working fine for the past 6 years but now when the Power button is pressed the power comes on but the FAIL
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Nordson Electronics Solutions makes reliable electronics an everyday reality. Our ASYMTEK, MARCH, and SELECT brands deliver precision fluid dispensing, conformal coating, plasma treatment and selective soldering equipment.
2747 Loker Ave West
Carlsbad, CA USA
Phone: 18002796835
