Electronics Forum | Mon Jul 04 05:13:43 EDT 2016 | lukvel
I have some boards which are charged with electrostatic and which are not connected to any voltage source. I am removing all the electrostatic charge by grounding them using a very similar technology to that of ESD mats. Is there any standard which
Electronics Forum | Mon Jul 04 09:09:06 EDT 2016 | lukvel
Yes I can use my field meter. But is there a standard which specifies the minimum electrostatic discharge time for the PCBs or for the components?
Electronics Forum | Thu Jul 07 01:26:34 EDT 2016 | lukvel
I have not tested whether there is electrostatic discharge on the PCB or not because the electrostatic meter is still on its way. But the IPC-A-610 section 3.1.2 specifies that yes even compressed air nozzles that move air over insulating surfaces g
Electronics Forum | Wed Jul 06 10:40:43 EDT 2016 | ttheis
What about grounding the board while you are cleaning it to immediately disspate the static?
Electronics Forum | Wed Jul 06 15:45:04 EDT 2016 | ttheis
I was thinking placing it on an esd mat during cleaning.
Electronics Forum | Wed Jul 06 08:22:57 EDT 2016 | lukvel
I am using compressed air to dry my PCBs and to remove dust from my PCBs. This is causing electrostatic build up on the PCBs. What do you suggest rather than an Ionized Air Gun?
Electronics Forum | Mon Jan 18 15:12:53 EST 1999 | Nikki
I had read something a long time ago about the effects of the Santa Anna winds on electro-static discharge. Does anyone know where I might be able to find information on this? Thanks, Nikki
Electronics Forum | Tue Jan 19 08:24:53 EST 1999 | Dave F
| I had read something a long time ago about the effects of the Santa Anna winds on electro-static discharge. Does anyone know where I might be able to find information on this? | | Thanks, | Nikki | Nikki: The link's not a direct answer, but clo
Electronics Forum | Wed Jul 06 14:20:18 EDT 2016 | lukvel
Dear Tom, Thanks a lot for your reply. That is exactly what I had in mind and I think that it is the best solution. Another solution is to increase the humidity in the area where the compressed air is being applied. But do you think there are othe
Electronics Forum | Wed Jan 23 23:45:35 EST 2019 | kiransahu
Piezoelectric type (office/industrial) In this method, a piezoelectric (piezo) element, whose volume is deformed when voltage is applied, is used to discharge ink particles. This element is attached to the component that is filled with ink. Then, th
.gif)
