Electronics Forum | Mon Aug 03 12:12:23 EDT 2015 | benreben
Hi all, i have lost my electrical schematic for the electrovert vectra. anybody know where find one? thx
Electronics Forum | Mon May 20 15:25:13 EDT 2013 | smtventasmex
Hi i can help you with your blowers needs contact me at vhmaderoATsmtvys.com
Electronics Forum | Tue May 07 09:42:17 EDT 2013 | cyber_wolf
We bought a "very used" Omniflow 10 at least ten years ago. We have only replaced maybe 5 blowers in that time.
Electronics Forum | Tue May 07 12:27:23 EDT 2013 | hegemon
Seems really excessive. I am not familiar with that particular oven, but I would check to see that the fans are not seeing excess heat during use. Is there any ducting around the fans that might have leaky joints? Is there insulation around the fan
Electronics Forum | Tue May 07 13:11:33 EDT 2013 | emeto
Hi Hege, there is insulation, which when you look at looks pretty stable.I suspect that there is more heat transfer through the shaft from the propeller to the motor. However when I touch the motor it is not really hot, so I am confused what really
Electronics Forum | Wed May 22 10:39:56 EDT 2013 | emeto
Hi smter, that sounds interesting. I can even buy a wrench with a set torque if it will help. What wrench are you using?
Electronics Forum | Tue May 07 09:26:38 EDT 2013 | emeto
Hello knowledgeable people, we have Omniflow 10Zone oven from 3-4 years and we changed over 20 blowers. The blower is German and I think is a very good quality(quite expensive too), but still keep getting bad. Does anyone have similar problem? Do yo
Electronics Forum | Thu May 09 16:54:43 EDT 2013 | smter
We used to have similar issues with large fallout on ours. I have been writing the date on mine for the last few years. We were having premature fallout due to our techs not installing them with proper screw installing pattern, which seemed to be cau
Electronics Forum | Wed May 22 12:59:09 EDT 2013 | cyber_wolf
That sounds very odd what smter is saying. The screws around the outside of the fans have nothing to do with the bearings. You only really need to tighten those screws enough to squish the gasket a little. No special torque settings required. As lon
Electronics Forum | Wed Dec 08 17:48:18 EST 2010 | katguts69
looking for schematics for electrovert omni 7 reflow oven. manufactured in 1998. help!
winsouce.jpg)
