Electronics Forum | Tue Sep 18 10:20:42 EDT 2018 | SMTA-Jairo
Hi colleagues, I am looking for a spare computer with Windows XP for a Electrovert Electra 500/F Wave machine. If anyone has one which is not using and would like to sell, please do not hesitate to reply to this post. Any help it is very appreciate
Electronics Forum | Thu Jan 11 12:42:55 EST 2024 | richardcargill
if the battery failed then you will have lost all the Cmos settings it held relating to the disk drive configuration/availability. Jump into the PC setup at switch on and make sure everything is correct
Electronics Forum | Thu Apr 15 23:13:29 EDT 2004 | pyro747
What we are finding that the volts on the Drive motor are dropping when the oven gets hotter. As for the encoder not pick up the drop in speed, I ran the wires for the encoder outside of the oven away from everything, didn't help!!! I swapped PC's
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Fri Dec 18 12:14:10 EST 1998 | Brian Steelglove
| | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | Good or bad for high volume Thrue Hole? | | | | Thanks Again, | | Brian Steelglove | | A
Electronics Forum | Thu Sep 09 08:33:07 EDT 1999 | Dave F
| My company is looking to perform "real time" statistical process control on our current SMT operations. I have identified the critical processes for SPC but have not had much luck in finding a system(s) that can monitor the required processes for m
Electronics Forum | Mon Dec 21 08:49:29 EST 1998 | Aric Parr
I used one on SMT at a previous employer. Make sure that you have 3 zones of preheat. Make sure that your operators are trained. The airknifes are extremely difficult to set up properly. Don't use them on high mix lines. We didn't need them once
Electronics Forum | Tue Dec 22 10:00:31 EST 1998 | Chrys
| | | Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | | | Good or bad for high volume Thrue Hole? | | | | | | Thanks Again, | | | Brian Steelg
Electronics Forum | Fri Dec 18 10:00:19 EST 1998 | Chrys
| Does anyone out there have one we are currently looking at one from a used equipment dealer and would like to know how they work? Good or bad for SMT? | Good or bad for high volume Thrue Hole? | | Thanks Again, | Brian Steelglove | American Prec
| 1 |
