Electronics Forum | Wed Jul 08 17:31:31 EDT 1998 | Dave F
smd: I think the idiom is "schmuck," rather than "putz." ;-) What are you concerned about? That the residual water in the 80 pin connector housing will flow down the boards and rot-out the bottom of your new boxes? Dave F | I am about to place a
Electronics Forum | Thu Mar 29 07:37:45 EDT 2012 | davef
The current discussion about solder fountains has to do with copper dissolution. Broadly, copper dissolution is the weakening of copper traces where a trace and a barrel plating intersect due a loss of the copper into the solder. Longer contact time
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
Electronics Forum | Thu Jul 13 04:01:02 EDT 2000 | JohnW
Dave, Firstly..how the heck are you?..been a while.... Ok so I'm running an Electrovert Electra witha hot gas knife, & I've got large server boards going over the wave. I've seen us loose chip, mainly Tants on the hot gas knife...ain't good especia
Electronics Forum | Thu Jul 09 08:03:48 EDT 1998 | smd
OK, I'll take a little abuse as long as you guys are giving me all this great advice. I am concerned about what might happen when a drop here and there comes from the connectors and is absorbed into the box. The box is going to suffer from this. I am
Electronics Forum | Thu Jul 09 08:04:11 EDT 1998 | smd
OK, I'll take a little abuse as long as you guys are giving me all this great advice. I am concerned about what might happen when a drop here and there comes from the connectors and is absorbed into the box. The box is going to suffer from this. I am
Electronics Forum | Tue Mar 20 08:04:47 EDT 2018 | spoiltforchoice
Those of us doing low volume with mesh ovens and double sided boards will often use the titanium strips used for making boards more rigid for wave soldering. Gives you enough clearance for lower profile items that you would typically find on the firs