Electronics Forum | Fri May 11 06:45:57 EDT 2007 | jdumont
On some of our boards we cut the clinched leads with an old Q Corp cutter. Works fine as long as the blade is sharp and the lead isnt bent against the board. Youll know when you go to far on the clinch because the mass lead cutter will begin to start
Electronics Forum | Thu Nov 25 17:32:54 EST 2010 | padawanlinuxero
Hello !!! Long time since I was here, I have a problem, I use a Electrovert EPK Plus solder wave to solder 8 leads the pcb is like a inche wide and 3/4 or less of height and the leads their size is .3570 inches long by .0195 wide and .0180inches th
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Mon Nov 29 13:09:12 EST 1999 | Mike Konrad
There are three primary methods of stencil cleaning. � Hand Cleaning � Spray-In-Air Cleaning � Ultrasonic Cleaning Hand Cleaning: Hand cleaning involves the removal of solder paste or adhesives from stencils using a chemically saturated wipe and /
| 1 |
.gif)
