Electronics Forum | Wed Sep 11 17:16:17 EDT 2013 | saied
Hello, We would like to order this spare-part blower motor electrovert omni Excel for Speedline Technologies Electrovert, type: Omni Excel 7 Serial: 476219 Date: 4/04 and we would be thankful if you provide us the Service manul for your prod
Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Mon Sep 28 14:27:08 EDT 2009 | soudomphong
I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.
Electronics Forum | Wed May 26 17:46:02 EDT 2004 | pjc
Electrovert has hard data on electrical and N2 consumption for the new OmniEXCEL series ovens to compare with preceeding OmniFlo series. Have a look.
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Thu Oct 25 11:15:55 EDT 2012 | aj
are you sure the zone 5 blower is running? sounds like it isnt.... no harm to check all blowers while you are at it.
Electronics Forum | Mon May 24 12:54:25 EDT 2004 | pjc
Maybe here's an opportunity to get a new oven. Electrovert, BTU and Vitronics offer closed-loop N2 control as an option. This, together with other improvements on oven design can reduce N2 consumption by as much as 40%. Not to mention reductions in e
Electronics Forum | Mon Jan 23 03:17:10 EST 2006 | pavel_murtishev
Good morning, IR reflow is yesterday technology. IR heating principle has a lot of issues with heat transfer capability (shadow effect) and uneven PCB heating. To avoid this forced convection ovens were developed. Reflow oven for SMD soldering must
Electronics Forum | Tue Sep 29 13:03:01 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, a
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
